General / The Clubhouse Today 05:23 PM
Vintage Chief
While renovating/upgrading exterior of my house ~20 years ago I was maneuvering through some bushes/hedges on the North side of the house and a swarm of yellow jackets nailed me. I was wearing no...
General / General Discussion Today 05:13 PM
I will be there as well, not bringing my 68 W30 but will be in the swap meet, will have lots of 68 and 69 stuff, mostly driver quality, a few 67 and 70 pieces and will also have the 67 decklid trim...
Technical & Reference / General Questions Today 05:12 PM
The variation from bank to bank is caused by the intake manifold. You will probably not be able to change this.
My Corvette with Rochester mechanical fuel injection ran fastest with WOT mixture...
General / General Discussion Today 04:59 PM
I always thought the 2251 was for the U code cars and the W30 got the 2953?
Cutlass, 442, and Hurst/Olds / Hurst/Olds Today 04:18 PM
You’ll probably have to pull the inner fender to get to the back of the switch.
Engine / Small Blocks Today 04:14 PM
You need to mechanically limit the vac advance to 10*
leenoga
Thread Starter
Vehicle Lineup / Vintage Oldsmobiles Today 04:06 PM
There are 11 fuses in this auto. Can anyone tell me the fuse size, where they are located, and what their function is? I know this is asking for a lot, but sure would help when one is...
Repair & Restoration / Electrical Today 03:30 PM
Dynoking
It's not 12 volts that makes a flasher work. Its current draw (amperage) that makes a flasher work. The current draw of an LED is substantively than an incandescent. Thats why you may need load...
John Donovan
Thread Starter
Repair & Restoration / Electrical Today 03:29 PM
Red letter day found the wiring problem today have A/C and heat again thanks to all who offered suggestions and help
z11375ss
Thread Starter
Vehicle Lineup / Other Oldsmobiles Today 03:27 PM
Very nice car. Perhaps a few grand too high but very nice. Low miles and original owner.
...