Andrew240

Will GMC motorhome bearings fit the Toronado knuckles? Supposedly the only modification made to the Toro knuckle to fit onto a motorhome is to ream out the lower ball joint bore to accept the larger motorhome ball joint. There is no mention on if this is the big bearing that is used on the early knuckles, or the smaller bearing used on later Toronados. Perhaps someone who is more in the know than myself can tell. The OD on the bearing is 3.250". I do not have an early and late knuckle to measure to see what the difference is.

Here is what I found at http://www.appliedgmc.com:

Timken #LM104949e 904A2


frt_brg-s.jpg

J-(Chicago)

Do you have one of those big ol' yellow ones with the 455 olds in it?
My old band had one of those.

Olds64

If you want to redo the wheel bearings on a Toronado why don't you just order the correct ones? Are they readily available? Try Fusicks, and Kanter. I bet they carry them.

2blu442

Hi Andrew
I'm not a Toro expert by any means but I thought the front wheel bearings were more like CV joints as the new front wheel drive cars are. Attached is a photo of a drive axle I removed from a 1969 Toro and I thought the 66-67 used the same setup. John

P1010789.jpg

Andrew240

New front wheel drive cars have the wheel bearings/hub sold as a unit, and are typically held into the knuckle by a few bolts.

The Toronado CV shaft passes through the knuckle. The hole that is passes through is the ID of the wheel bearing. Here is a picture of the back of a spare knuckle that I have. You can see the toothed part of the CV shaft passes all the way through the knuckle to the toothed inside hub.

DSC00287.jpg

2blu442

OK, now I follow you. There's a wheel bearing in the spindle area. John