Cruise carb linkage

sworthy555 · February 7th, 2009, 03:28 AM

I recently converted my 70 SX from a 2 barrel to a 4 barrel and the cruise carb linkage from the 2 barrel will not work with the 4 barrel. Does anyone have the cruise linkage that hooks to the carb for a 4 barrel?

Thanks and email sworthy555@aol.com

Bluevista · February 8th, 2009, 09:45 AM

I don't have a linkage set-up but if you can figure out how to do it you may be able to modify yours or at least know if it's correct if you find one. I have a 2 barrel and cruise and may switch to a 4 barrel so I've been checking it out. If the '70 is the same as a '71 all the linkage is the same for a 4 barrel except for where the pivot for the bellcrank is located on the bracket, has two hole locations, same part as far as I can tell. The rod is also a different length but that's no big deal to lengthen or shorten.

img080b_edited-1.jpg

February 7th, 2009, 03:28 AM	#1 (permalink)
sworthy555 Registered User Join Date: Nov 2008 Location: South Texas Posts: 32	Cruise carb linkage I recently converted my 70 SX from a 2 barrel to a 4 barrel and the cruise carb linkage from the 2 barrel will not work with the 4 barrel. Does anyone have the cruise linkage that hooks to the carb for a 4 barrel? Thanks and email sworthy555@aol.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
61-62 cruise control linkage question	Oldskeeper	General Discussion	4	February 1st, 2009 07:27 AM
67 Toro cruise control	oldsmobilia	Toronado	0	December 28th, 2008 05:38 AM
looking for Rochester quadrajet 4GC carb linkage diagram	sanemb	General Discussion	3	May 28th, 2008 06:43 PM
Carb/Transmission Linkage for 1951 4dr 98	granddaddy-O	Parts Wanted	0	May 23rd, 2008 09:27 AM
51 Rocket 88 Carb & Trans linkage	granddaddy-O	Eighty-Eight	3	May 14th, 2008 09:27 AM

February 8th, 2009, 09:45 AM	#2 (permalink)
Bluevista Cruisin' the Vistas Join Date: Jul 2006 Location: Northeast Ohio Posts: 1,722	I don't have a linkage set-up but if you can figure out how to do it you may be able to modify yours or at least know if it's correct if you find one. I have a 2 barrel and cruise and may switch to a 4 barrel so I've been checking it out. If the '70 is the same as a '71 all the linkage is the same for a 4 barrel except for where the pivot for the bellcrank is located on the bracket, has two hole locations, same part as far as I can tell. The rod is also a different length but that's no big deal to lengthen or shorten. img080b_edited-1.jpg