coppercutlass

Im selling my 355 olds. It has #6 heads with ferrea ss. valves 2.07 in. 1.63 ex. with bowl work done by rocket racing. They have prw roller tip rockers , poly locks and comp cams hardened pushrods , new springs , retainers locks everything in the heads is pretty much new and the heads have less than 6k (ran em on an other combo) miles on them . The heads where milled .024 . It also has an edelbrock rpm intake that has been milled to match the heads. The short block is .030 with speed pro flat tops sitting .025 in the cylinders. It has king bearings through out. the mains where .030 and the rods where .010 . It has a prw inertia flex plate. It was balanced , It has a howards 512/512 lift cam with 227/234 duration @.050 lift . Compression is appx. 9.9 to 1 runs fine on pump gas 93. It also has a comp cams double roller timing chain, new std. volume oil pump , big block oil pan . This engine runs very strong. With my set up it would smoke em from a 25 mph roll. I built this engine .This price im putting it at is my bottom price and I feel is fair. There is a solid 1500 in the top end alone and the bottom end ran me 2k all said and done not to mention all the little odds and ends. It has great oil pressure nice and steady no bouncing 60 psi while cold. Im sure im forgetting a few things but feel free to ask I know this engine in and out.


Im asking 2500 . Still in the car can hear it run and if you want to go for a ride I can slap the fenders on it. This for the engine intake to oil pan. no carb no dist etc etc.




Here is a clip of it running.


1972 cutlass with 350 olds - YouTube


Prefer local pick up but I can ship if needed just rather not.

scooter123

Good luck with your sale........whats next to go in the copper??

coppercutlass

Another small block lol. Just need funds to do the frame work and to finish the 355 that's on the stand

coppercutlass

Ttt