1973 delta 88 convertible parting out
September 29th, 2009, 04:37 AM
#1
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
1973 delta 88 convertible parting out UPDATED!
i have a line out on a 73 delta 88 convertible with no engine/trans, rotted floors, complete top, power doors/windows, as i can tell from pic header panel good, top worked, not sure on the header bow..........
been laid off of work, is there any interest in parts like the interest in pontiac grandville converts? taking preorders, anybody need anything? i usually ebay stuff, but figured i'd start here, thanks, eric
been laid off of work, is there any interest in parts like the interest in pontiac grandville converts? taking preorders, anybody need anything? i usually ebay stuff, but figured i'd start here, thanks, eric
Last edited by dedsleds; April 9th, 2010 at 07:57 AM.
September 29th, 2009, 05:41 AM
#3
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
September 30th, 2009, 06:07 PM
#9
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
September 30th, 2009, 06:15 PM
#10
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
the body is junk, hood has supports welded to the underside, trunklid rotted, doors patched, 1/4's fenders rotted.............
header bow looks ok right now, top frame looks good too, taillights, hood hindges, header panel, front valance panel, 1/4 extensions, some of the rocker trim looks good, wheel opening moldings are so-so (need to examine better)
interior: i contacted a fellow member on here about the seats, dash good, tilt solid, door panels look painted, pw, pwr locks, have a new top in a box, factory storage compartment on hump under dash, non original radio, thermometer (needs work), stripping the whole dash.........
header bow looks ok right now, top frame looks good too, taillights, hood hindges, header panel, front valance panel, 1/4 extensions, some of the rocker trim looks good, wheel opening moldings are so-so (need to examine better)
interior: i contacted a fellow member on here about the seats, dash good, tilt solid, door panels look painted, pw, pwr locks, have a new top in a box, factory storage compartment on hump under dash, non original radio, thermometer (needs work), stripping the whole dash.........
Last edited by dedsleds; October 1st, 2009 at 04:40 AM.
October 8th, 2009, 10:26 AM
#11
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
NO ROCKER TRIM
ALL BODY PANELS WERE JUNK
HEADER BOW RUSTED
DOOR PANELS WERE JUNK
PENDING SALE ON THE SEATS
FACTORY CENTER 8 TRACK CONSOLE 150.00
FACTORY THERMOMETER (NEEDS WORK) 25.00
DUAL EXHAUST CROSSMEMBER 80.00 (FITS 71-76 PONTIAC CHEVY OLDS BUICK B BODIED CARS)
COMPLETE POWER WINDOW SETUP 100.00
SOFTRAY GLASS (SIDES) 80.00/SET
GOOD WINDSHIELD W/REARVIEW MIRROR 100.00
CONEVRT. TOP FRAME 100/ALL (NO HDR BOW)
NEW IN THE BOX TOP MATERIAL FROM WARSAWSKI (SP?) BLACK 120.00
WINDSHIELD TRIM 75.00
BASE TOP TRIM (MISSIG PASS CURVED PC) 60.00/ALL
OLDSMOBILE POWER LOCK SWITCH AND LOOM ONLY 25.00
TILT COLUMN W/KEY 80.00
FADED BUT NOT CRACKED BLACK DASH W/LOOM 100.00/ALL
GAS PEDAL/CABLE SETUP 20.00
73 DELTA HEADER PANEL, GRILLS AND LOWER VALNACE 60.00/PR
PARTIAL CRUISE SETUP 20.00
GOOD HOOD HINDGES 40.00/PR
1/4 EXTENSIONS 10.00/PR
COMPLETE BLACK SEAT BELT SET (BELTS REMOVED FROM THE RETRACTERS THOUGH) 40.00/ALL
OK FRONT BUMPER FILLERS 25.00/ALL
REAR BUMPER FILLER STRIP 5.00
WASHER JUG WITH LEVEL WARNING LIGHT/LOOM 35.00
TRUNKLID LIGHT 10.00
POWER TRUNK RELEASE SETUP (UNTESTED) 30.00
LIGHTED VISORS W/HEADER BEZEL AND PILLAR POSTS 50.00/ALL
COMPLETE POWER TOP MOTOR LOOM CABLES (BUICK CADILLAC OLDSMOBILE PONTIAC 71-76) 55.00
OLDS POWER TOP SWITCH/PIGTAIL 20.00
A/C-HTR CONTROLS WITH CABLE AND VACUUM LOOM 20.00
WIPER MOTOR SETUP W/COWL PARTS 20.00/ALL
CONVERTIBLE DOOR WEDGES L/R SIDES
SEATS F/R SOLD
HORNS SOLD
ALL BODY PANELS WERE JUNK
HEADER BOW RUSTED
DOOR PANELS WERE JUNK
PENDING SALE ON THE SEATS
FACTORY CENTER 8 TRACK CONSOLE 150.00
FACTORY THERMOMETER (NEEDS WORK) 25.00
DUAL EXHAUST CROSSMEMBER 80.00 (FITS 71-76 PONTIAC CHEVY OLDS BUICK B BODIED CARS)
COMPLETE POWER WINDOW SETUP 100.00
SOFTRAY GLASS (SIDES) 80.00/SET
GOOD WINDSHIELD W/REARVIEW MIRROR 100.00
CONEVRT. TOP FRAME 100/ALL (NO HDR BOW)
NEW IN THE BOX TOP MATERIAL FROM WARSAWSKI (SP?) BLACK 120.00
WINDSHIELD TRIM 75.00
BASE TOP TRIM (MISSIG PASS CURVED PC) 60.00/ALL
OLDSMOBILE POWER LOCK SWITCH AND LOOM ONLY 25.00
TILT COLUMN W/KEY 80.00
FADED BUT NOT CRACKED BLACK DASH W/LOOM 100.00/ALL
GAS PEDAL/CABLE SETUP 20.00
73 DELTA HEADER PANEL, GRILLS AND LOWER VALNACE 60.00/PR
PARTIAL CRUISE SETUP 20.00
GOOD HOOD HINDGES 40.00/PR
1/4 EXTENSIONS 10.00/PR
COMPLETE BLACK SEAT BELT SET (BELTS REMOVED FROM THE RETRACTERS THOUGH) 40.00/ALL
OK FRONT BUMPER FILLERS 25.00/ALL
REAR BUMPER FILLER STRIP 5.00
WASHER JUG WITH LEVEL WARNING LIGHT/LOOM 35.00
TRUNKLID LIGHT 10.00
POWER TRUNK RELEASE SETUP (UNTESTED) 30.00
LIGHTED VISORS W/HEADER BEZEL AND PILLAR POSTS 50.00/ALL
COMPLETE POWER TOP MOTOR LOOM CABLES (BUICK CADILLAC OLDSMOBILE PONTIAC 71-76) 55.00
OLDS POWER TOP SWITCH/PIGTAIL 20.00
A/C-HTR CONTROLS WITH CABLE AND VACUUM LOOM 20.00
WIPER MOTOR SETUP W/COWL PARTS 20.00/ALL
CONVERTIBLE DOOR WEDGES L/R SIDES
SEATS F/R SOLD
HORNS SOLD
GONE........
STEERING WHEEL SOLD TOO
October 8th, 2009, 10:49 AM
#20
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
OOOOOOOOOOOLLLLDDDDDDDDSSSSSSSSSSSSSSSSS
THE COMPLETE SEATBELT SET, BUT I HAD TO TAKE THE BELTS OUT OF THE RETRACTORS 40.00/SET
Last edited by dedsleds; October 26th, 2009 at 08:30 PM.
October 9th, 2009, 10:35 AM
#24
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
October 14th, 2009, 07:45 AM
#27
Registered User
Join Date: Oct 2009
Location: Lacey, Washington
Posts: 17
October 14th, 2009, 08:05 AM
#28
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
October 14th, 2009, 08:18 AM
#29
Just an Olds Guy
Join Date: Jul 2008
Location: Edmonton, AB. And "I am Can 'eh' jun - eh"
Posts: 24,525
Didn't you just rebuild a cruise unit for Lady? Just shopping for spare parts? I was at the boneyard about 2 weeks ago and there was a 1976 Cutlass Supreme with power everything, + cruise and rallye gauges. Too close to closing time to get much off of it, but I got the transducer and vacuum diaphragm. Went back the next day to get everything else (including the signal stalk, brake switch and gauges pod + senders) and they had just crushed it. (and my feelings too). It had PW, PDL. I had removed one of the PDL actuators and stored it in the trunk because the drivers door wouldn't open and I would have to take the seat out to get it....what a bummer. The actuators were only 12.00 each and would have worked on a 70-72 Cutlass.
October 14th, 2009, 10:28 AM
#33
Registered User
Join Date: Oct 2009
Location: Lacey, Washington
Posts: 17
October 14th, 2009, 11:02 AM
#34
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
taillights and windshield were highlighted and when you moved the arrow over it a popup ad came up.........posts 23 and 27........no one else has highlighted nouns....
Last edited by dedsleds; October 14th, 2009 at 11:05 AM.
October 14th, 2009, 11:15 AM
#35
Registered User
Join Date: Oct 2009
Location: Lacey, Washington
Posts: 17
Post 23 is not me. When i go to my post i dont see any pop up when looking at the word windshield. Im not sure what is going on. I am going to go to the post without logging in and see if i can see it.
October 14th, 2009, 12:16 PM
#37
Registered User
Thread Starter
Join Date: Jan 2009
Location: CHICAGO RIDGE, IL
Posts: 608
October 14th, 2009, 03:14 PM
#40
Registered User
Join Date: Oct 2009
Location: Lacey, Washington
Posts: 17
I would definatley be interested in the windshield if it it is undamamged and the radio leads can be re-atached. it looks like it would fit a 72 Delta. Has anyone ever shipped a windshield here before? Im in Washington State, im not sure how far away you are. Could you let me know how much you would like for it?
thanks
thanks
