1970 442 4 Speed
#128
#134
Looks amazing. Was just looking at a variety of different SS headers available for another project as a starting point for a custom set. Your exhaust looks correct as possible to the manifolds.
Although not the same as what I'm working on, your picture shows how close a SS set of short headers is to exactly fitting for your car.
What spring rates did you chose, if you know?
The compressor looks like the Pro6Ten, if so it's a good piece. I've run them for many years, with lots of rpm using 4.10 gears and a 4spd in a Chev K20 front and rear A/C.
https://www.oldsparts.com/product/400-455-ci-headers/
Although not the same as what I'm working on, your picture shows how close a SS set of short headers is to exactly fitting for your car.
What spring rates did you chose, if you know?
The compressor looks like the Pro6Ten, if so it's a good piece. I've run them for many years, with lots of rpm using 4.10 gears and a 4spd in a Chev K20 front and rear A/C.
https://www.oldsparts.com/product/400-455-ci-headers/
Last edited by LOUCKES'6487; December 11th, 2023 at 09:37 PM.
#136
They look almost identical to the other set.
Both good flanges , would have to have both sets side by side to compare. The shape through the flange etc.
Stock springs, I assume that's non HD, but I see boxed rear arms so I don't know. That's why I was asking about the rate.
Both good flanges , would have to have both sets side by side to compare. The shape through the flange etc.
Stock springs, I assume that's non HD, but I see boxed rear arms so I don't know. That's why I was asking about the rate.
#143
Hi Eddie My condolences on your lost
No wheaties just barley sandwichs car should be on the road this summer hopefully
Stay happy
Merry X-mas to you family and friends
Have a great evening
Alain red W-31
No wheaties just barley sandwichs car should be on the road this summer hopefully
Stay happy
Merry X-mas to you family and friends
Have a great evening
Alain red W-31
#151
#152
Should I assume, the sanding would be done wet?? Also, when you get done with the 3000, do you finish up with some type of specialty plastic polish and/or sealer?? Since I have my front fender wells out until I paint the car, I may just do this before re-installing them back in the car.
I really enjoy your restorations,
OLE442
#160