1970 Cutlass "S" $8500
#1
1970 Cutlass "S" $8500
The guy I bought this car off of said it was a Texas car. I put around 5000 miles on it since I've owned it and it currently has around 79,600 miles on it. If you want more pics or have any questions please let me know. I can deliver the car to you within 200 miles or so.
Good points about the car:
(all the below work was done within the past 4-5 months)
inspection is good until 4/12
compression test had 160-175 psi on each cyl
pushrods are all straight
original 350 engine with Edelbrook Performer intake manifold (new gasket)
original transmission (I beleive)
new aluminum Holley 4-barrel carb (with Holley air filter and spacer)
new platinum spark plugs
new MSD spark plug wires
new MSD distributor cap and rotor and pickup coil
new Flowmaster duel exhast
new wood Grant steering wheel (with horn that works)
new heater valve
new fuel pump
new battery
new black hardtop
new carpet
new front fenders will come with the car
new brake pads
e-brake works
new alternador
new belts
new hoses
a/c works
new bf goodrich tires
new headliner
new monroe trac-matic shocks front and back
new rear springs
new back brake drums and pads and wheel cylinders
new master cylinder
new brass radiator
new fan shroud
Bad points about the car:
speakers are blown
has the incorrect exhast manifolds
has a few rust spots (car is very solid other than that)
drivers seat is torn
windshield wiper sprayer needs replaced
may need motor mounts
needs seat belt plug ins
paint could use either touch up or complete repaint if desired
Good points about the car:
(all the below work was done within the past 4-5 months)
inspection is good until 4/12
compression test had 160-175 psi on each cyl
pushrods are all straight
original 350 engine with Edelbrook Performer intake manifold (new gasket)
original transmission (I beleive)
new aluminum Holley 4-barrel carb (with Holley air filter and spacer)
new platinum spark plugs
new MSD spark plug wires
new MSD distributor cap and rotor and pickup coil
new Flowmaster duel exhast
new wood Grant steering wheel (with horn that works)
new heater valve
new fuel pump
new battery
new black hardtop
new carpet
new front fenders will come with the car
new brake pads
e-brake works
new alternador
new belts
new hoses
a/c works
new bf goodrich tires
new headliner
new monroe trac-matic shocks front and back
new rear springs
new back brake drums and pads and wheel cylinders
new master cylinder
new brass radiator
new fan shroud
Bad points about the car:
speakers are blown
has the incorrect exhast manifolds
has a few rust spots (car is very solid other than that)
drivers seat is torn
windshield wiper sprayer needs replaced
may need motor mounts
needs seat belt plug ins
paint could use either touch up or complete repaint if desired
Last edited by MattD; October 10th, 2011 at 02:36 PM.
#4
200 miles from where?
#6
Just an Olds Guy
Join Date: Jul 2008
Location: Edmonton, AB. And "I am Can 'eh' jun - eh"
Posts: 24,525
You have a great looking car with a lot of work already done. I don't think you'll have any trouble selling it. BTW, that's the first time I've seen a 70 with a 2 tone seat pattern.
#11
Thanks Tony!
79MKII,
There is a small rust spot on the quarter panel, but other than that the quarter panel is solid. The one motor mount might be broken, but I'm not 100% sure. I bought two new ones, but never got around to putting them in. If you want pics of the rust on the quarter panel let me know.
Thanks,
Matt
79MKII,
There is a small rust spot on the quarter panel, but other than that the quarter panel is solid. The one motor mount might be broken, but I'm not 100% sure. I bought two new ones, but never got around to putting them in. If you want pics of the rust on the quarter panel let me know.
Thanks,
Matt
Thread
Thread Starter
Forum
Replies
Last Post
droptop66
Cars For Sale
0
December 17th, 2013 12:22 AM
GAOldsman
Cars For Sale
2
March 16th, 2013 08:32 PM
65B01Delta
Cars For Sale
1
March 3rd, 2013 04:23 AM
81 regency
Parts For Sale
0
April 21st, 2011 06:18 PM
botz
Cars For Sale
5
September 13th, 2010 08:27 PM