|
|
|||||||
| Forums | Gallery | Encyclopedia | Tech | Olds Junction | Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
05-08-2008, 06:51 PM
|
#1 (permalink) |
|
Junior Member
Join Date: Sep 2007
Location: Toronto, Canada
Posts: 3
|
394 broken pipe to choke assembly
When I was removing my carb for a rebuild, I managed to break the pipe that goes from the intake manifold to the choke assembly. I'm still trying to get the knack of how much force to apply without breaking stuff...
Can't seem to figure out how to remove the broken end and replace. Any ideas? I'm really hoping I don't need to take off the manifold. -Justin |
|
|
| Sponsored Links |
|
|
|
05-08-2008, 09:03 PM
|
#2 (permalink) |
|
Seasoned beater pilot.
Join Date: Jan 2007
Location: Chicago
Posts: 1,393
|
It is usually shaped like a J , you will probably have to do some creative bending while pulling with pliers to get the broken piece out. Hopefully it is still sitting upright in the pocket to where you can grab a hold of it with something.
 As for a solution... you could always run an electric choke on ignition power if you had to.
__________________
 I'd rather have a numbers matching poker hand.
|
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 inch exhaust with an x pipe crossover? | shaks 442 clone | Other | 20 | 03-29-2008 08:31 PM |
| mandrel bent crossover pipe | 66f85deluxewagon | Small Blocks | 6 | 01-21-2008 11:49 AM |
| Blue Smoke From Exhaust Pipe | 54olds | Small Blocks | 20 | 11-27-2007 05:08 AM |
| Carb line and heater choke pipe assembly? | chaosklima | Toronado | 1 | 04-27-2007 11:39 AM |
| Broken Center console/hinge and BIG RAIN LEAK! | bear71 | Interior/Upholstery | 5 | 03-27-2007 08:59 PM |
Linear Mode
