floor shifter question, 71 cutlass

cruznn · 04-08-2008, 06:02 PM

Hi
Does anyone know how to get the lever you lift up on to change gears off of the handle. I need to remove it to install the shifter seal that slides back and forth when you shift to different gears. Its the part below the shifter ball that looks like a tee.
Thanks,
Mike

70oldsW30 · 04-10-2008, 01:28 PM

There's a little allen screw that holds it on.

Well, if I remember right. It's probably been eight years since I had one in front of me.

silverriff · 04-25-2008, 05:40 AM

Its been a few weeks since your post, but I had to do this this past weekend on my 72. Mine had a pin that I had to stick a very small screwdriver into and bang it out. If you haven't done it already, hope that helps!
-Eric

04-08-2008, 06:02 PM	#1 (permalink)
cruznn Junior Member Join Date: Jan 2007 Posts: 16	floor shifter question, 71 cutlass Hi Does anyone know how to get the lever you lift up on to change gears off of the handle. I need to remove it to install the shifter seal that slides back and forth when you shift to different gears. Its the part below the shifter ball that looks like a tee. Thanks, Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wiring up my floor shifter	silverriff	Transmission	4	04-07-2008 11:17 AM
Floor shifter "T" handle	70redvert	Parts Wanted	5	02-10-2008 09:34 PM
Floor shifter Question	harleyrules	Transmission	0	11-03-2007 03:47 PM
1964 Cutlass Automatic Floor Shifter	harleyrules	Parts Wanted	6	11-02-2007 09:57 PM
Shifter Question!	TheRuss	Other	0	06-04-2007 01:28 PM

04-10-2008, 01:28 PM	#2 (permalink)
70oldsW30 Member Join Date: Apr 2008 Location: houston Posts: 35	There's a little allen screw that holds it on. Well, if I remember right. It's probably been eight years since I had one in front of me.

04-25-2008, 05:40 AM	#3 (permalink)
silverriff Member Join Date: Feb 2008 Posts: 52	Its been a few weeks since your post, but I had to do this this past weekend on my 72. Mine had a pin that I had to stick a very small screwdriver into and bang it out. If you haven't done it already, hope that helps! -Eric