TH400 swap in 84 Cutlass

grimlock · 01-21-2007, 09:39 AM

Could you guys help me make a checklist of parts/procedures before I start in on my swap? In the process of picking up a early/mid '70's 455 and TH-400 tranny.

For the this swap I currently have the 307/TH200 3spd auto slow combo. Pretty sure the TH400 is longtailed so I will need a new driveshaft and the TH400 yoke correct? What else am I forgetting? Crossmember and linkage needs to be changed also, right?

Mission of this rebuild/swap is to have a fun daily driver that can lay down some smack every now and then.

grimlock · 01-23-2007, 09:24 PM

Ok, for the record I found out the TH-350 is a direct swap in for the THM200. However the shift linkage and detent cable are different, and a line to the modulator is needed.
A TH-400 swap needs the 400's yoke, a shorter driveshaft, crossmember modded or the one from a 200R4, and all assorted attachments like the TH-350.

01-21-2007, 09:39 AM	#1 (permalink)
grimlock Junior Member Join Date: Dec 2006 Location: Kentucky Posts: 28	TH400 swap in 84 Cutlass Could you guys help me make a checklist of parts/procedures before I start in on my swap? In the process of picking up a early/mid '70's 455 and TH-400 tranny. For the this swap I currently have the 307/TH200 3spd auto slow combo. Pretty sure the TH400 is longtailed so I will need a new driveshaft and the TH400 yoke correct? What else am I forgetting? Crossmember and linkage needs to be changed also, right? Mission of this rebuild/swap is to have a fun daily driver that can lay down some smack every now and then.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-23-2007, 09:24 PM	#2 (permalink)
grimlock Junior Member Join Date: Dec 2006 Location: Kentucky Posts: 28	Ok, for the record I found out the TH-350 is a direct swap in for the THM200. However the shift linkage and detent cable are different, and a line to the modulator is needed. A TH-400 swap needs the 400's yoke, a shorter driveshaft, crossmember modded or the one from a 200R4, and all assorted attachments like the TH-350.