Got a olds 350 for sale it is bored 30 over high compresion pistons,224/234 duration @.050 lift 496/520 lift 112 lobe seperation cam, edelbrock performer intake, and 750 edelbrock carb. It has chrome valve covers and air cleaner. It has number 8 heads,it was out of a 72 or so I was told. It has less than 15k since rebuild. It is still in the car if you want to hear it run so let me know as I may be pulling it this weekend if I get my 455 together. Make me an offer. Either PM me or post on here I will try to check back daily. I live about 1/2 hour west of clevland. Thanks Darin

 

who rebuilt it?

what brand and part# are the pistons?

thanks

 

Previous owner had it rebuilt so this is all I can tell you. It runs very strong and pulls hard even with crap rear end gears. The car and engine were built some place in CT. I was told the pistons are forged dome high compression I don't know the brand.

 

pull the spark plug,on #1 cylinder,work the piston around to the top.

you can shine light into the cylinder,and i bet youll be able to see what the over bore was on the piston,and whether it has a dish in the top of the piston.

when trying to sell a motor,its kind of important to know what's in it.

 

I looked in the cylinder and the pistons look the same as the ones in my 455 so I dont know what they are you are more than welcome to check it out if you like I will probably have it pulled out by the end of next weekend.

 

whats the engine casting number above water and to the right of the oil filler tube. how much are you asking.

 

I will check the #s in the morning.
I would like to get 1000 out of it I know I have seen them on ebay for way more and I know what it cost to build a motor as I have just finished putting my 455 together today

Make an offer or come and have a look because I will be pulling it probably next weekend if you want to hear it run

 

I forgot I have some pics from the build up the previous owner gave me. You can see the #s in the one pic.