|
|
|||||||
| Forums | Gallery | Encyclopedia | Tech | Olds Junction | Register | All Albums | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read | Used Cars |
| General Discussion Discuss your Oldsmobile or other car-related topics. |
|
|
|
| Welcome to Classic Oldsmobile Forum! |
|
|
Welcome to Classic Oldsmobile forum, You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Classic Oldsmobile Forum today! |
 |
|
|
Thread Tools | Display Modes |
July 16th, 2009, 12:48 AM
|
#1 (permalink) |
|
Registered User
Join Date: Jul 2009
Location: I live in a small town between D.C. and Philly
Posts: 21
 |
Another suspension question
I found the tech section on converting the 64 Olds 98 to disk ,however i would like to find all part numbers for single piston calipers, rotors, hoses, dust shield, spindles, and pads. I am going to buy everything brand new. Reason one, I will switch to dot 5 fluid because I'm going to replace the entire brake system. I want to make sure I don't end up with any silicone seal problems as explained in the page by using dot 5 fluid. I have seen what happens when dot 3 and 5 mix since I'm an auto mechanic. I am going to full disk brakes and stainless lines, but not braided hoses.
Is there a combination valve that will work with out adding an adjustable proportioning valve. I would like it to appear stock if possible. Will a 4 wheel disk brake corvette combination valve work since I'm going to all disk setup. Last edited by toymaker199; July 16th, 2009 at 02:40 AM.. Reason: had to change the question |
|
|
| Sponsored Links |
|
Register your account for free today or log in if already registered to remove this ad! |
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on H/O suspension | wazoo | Hurst/Olds | 5 | July 8th, 2009 07:43 AM |
| Suspension Question | DAN76 | General Discussion | 0 | June 10th, 2009 06:52 AM |
| Suspension | projectheaven | Cutlass | 7 | February 12th, 2009 08:50 AM |
| Suspension | projectheaven | Chassis/Body/Frame | 3 | December 10th, 2008 08:23 PM |
| Suspension question for '66 Cutlass Conv. | JSGD1966 | Chassis/Body/Frame | 1 | December 5th, 2007 02:23 PM |
Linear Mode
