rear end rebuild 72 cutlass

crank.it · 04-05-2003, 04:41 AM

can any one tell me the difficulty in rebuilding a rear end pinion,and gears??

crank.it · 04-23-2003, 05:19 PM

hey is their anyone else in this site???cause i get no replies???or i just dont know how to work it???

grandmas73rocket · 04-30-2003, 07:01 AM

hey, I would have to say if you never rebuilt a rear end, let a good mechanic do it while you watch. I've replaced motors in cars but I will not mess with a ring and pinion. you wont know it's shimed correctly until you drive it and then it could either knock or hum.

good luck
c.b.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Die cast model	bmcrawford	442	8	12-09-2007 12:38 PM
Gas Cap	ssaltuc	Cutlass	2	01-25-2007 06:50 AM
75 olds conv.	shaunr	Eighty-Eight	0	11-18-2006 04:47 PM
1969 Cutlass S Coupe - two owner car, clean, nice looking	dcastine	Cars For Sale	3	08-22-2006 05:59 PM
1950 olds 98 two-door post Complete	Terry S. Hodges	Cars For Sale	1	06-02-2006 05:20 AM

04-05-2003, 04:41 AM	#1 (permalink)
crank.it Junior Member Join Date: Apr 2003 Posts: 10	can any one tell me the difficulty in rebuilding a rear end pinion,and gears??

04-23-2003, 05:19 PM	#2 (permalink)
crank.it Junior Member Join Date: Apr 2003 Posts: 10	hey is their anyone else in this site???cause i get no replies???or i just dont know how to work it???

04-30-2003, 07:01 AM	#3 (permalink)
grandmas73rocket Junior Member Join Date: Apr 2003 Posts: 4	hey, I would have to say if you never rebuilt a rear end, let a good mechanic do it while you watch. I've replaced motors in cars but I will not mess with a ring and pinion. you wont know it's shimed correctly until you drive it and then it could either knock or hum. good luck c.b.