screws 9419727

bigbrother · 04-24-2008, 10:07 AM

Anyone know what size screw this is
part number 9419727

its the self tapping screw that holds down the floor shifter bracket on a 1969 cutlass s. I searched the assembly manual and cant find it anywhere.
thanks bb

Oldsfan · 04-24-2008, 11:37 AM

Goes through a few number changes. Current number is 12338139. Is a M6.3x1.81x13. I know '69 Cutlasses didn't use metric screws, but...

How 'bout 9416727. That's a good number for a 5/8-18x4-1/4" hex head bolt - out of the '62 parts catalog.

Paul

bigbrother · 04-24-2008, 01:34 PM

The hole in the shifter plate in .25". I suppose I should use a .25 self tapping hex screw about .5" long. That would be my best guess but I wondered what it was actually. I cannot find any reference to that number. I guess I will just go with my gut on this one. Thanks BB

Run to Rund · 04-24-2008, 04:35 PM

Your number is not shown in the 11/69 GMPD price schedule.

04-24-2008, 10:07 AM	#1 (permalink)
bigbrother Junior Member Join Date: Jun 2007 Location: kansas Posts: 22	screws 9419727 Anyone know what size screw this is part number 9419727 its the self tapping screw that holds down the floor shifter bracket on a 1969 cutlass s. I searched the assembly manual and cant find it anywhere. thanks bb

04-24-2008, 11:37 AM	#2 (permalink)
Oldsfan Senior Member Join Date: Jul 2006 Posts: 427	Goes through a few number changes. Current number is 12338139. Is a M6.3x1.81x13. I know '69 Cutlasses didn't use metric screws, but... How 'bout 9416727. That's a good number for a 5/8-18x4-1/4" hex head bolt - out of the '62 parts catalog. Paul __________________ There's "Something Extra" about owning an OLDS! -- Visit the "Something Extra" website at: http://home.comcast.net/~oldsfan/MySite/62oldspage.html

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
screws and bolts	bigbrother	Cutlass	0	02-28-2008 06:09 PM
Need small parts. Screws specifically.	Maccabeus	Cutlass	1	12-12-2007 06:42 AM

04-24-2008, 01:34 PM	#3 (permalink)
bigbrother Junior Member Join Date: Jun 2007 Location: kansas Posts: 22	The hole in the shifter plate in .25". I suppose I should use a .25 self tapping hex screw about .5" long. That would be my best guess but I wondered what it was actually. I cannot find any reference to that number. I guess I will just go with my gut on this one. Thanks BB

04-24-2008, 04:35 PM	#4 (permalink)
Run to Rund Senior Member Join Date: Mar 2008 Posts: 80	Your number is not shown in the 11/69 GMPD price schedule.