Engine Knock?

01-02-2005, 06:26 PM

I just purchased a 1966 Delta 88 Cinv witha 425. The engine runs, but has a knocking sound. I am not sure where it is coming from, though It does not sound good. I have read that it may be a spun bearing. Could someone tell me what else it may be? (trying to gage whether or not I need a complete rebuilt)

tedster · 01-04-2005, 03:23 AM

Does the engine knock at idle as well as when you accelerate hard? If it knocks only when you accelerate, there is probably too much advance in the timing and/or you need to run a higher octane gas (this problem will get worse with "winter mix" gases that have additives that make the gas more volatile for easier starting in cold weather).
When I purchased my Cutlass, the 455 had a knock at idle which turned out to be a spun bearing. Hope this helps.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1957 Olds super 88 4D Parts?	Olds57rocketgal	Eighty-Eight	7	05-30-2007 08:38 AM
crank casting 397363 needed	neoinbiz	Parts Wanted	3	12-25-2006 06:07 PM
68 Cutlass wont start	68oldsrocket	Cutlass	24	12-19-2006 07:20 PM
72 Delta Royale dash pad for sale	dcook442	Parts For Sale	0	11-21-2006 02:29 AM
another olds guy	odin3eye	Cutlass	4	03-30-2006 09:00 PM

01-02-2005, 06:26 PM	#1 (permalink)
<66 Delta 88 Conv> Posts: n/a	I just purchased a 1966 Delta 88 Cinv witha 425. The engine runs, but has a knocking sound. I am not sure where it is coming from, though It does not sound good. I have read that it may be a spun bearing. Could someone tell me what else it may be? (trying to gage whether or not I need a complete rebuilt)

01-04-2005, 03:23 AM	#2 (permalink)
tedster Junior Member Join Date: Jan 2005 Posts: 3	Does the engine knock at idle as well as when you accelerate hard? If it knocks only when you accelerate, there is probably too much advance in the timing and/or you need to run a higher octane gas (this problem will get worse with "winter mix" gases that have additives that make the gas more volatile for easier starting in cold weather). When I purchased my Cutlass, the 455 had a knock at idle which turned out to be a spun bearing. Hope this helps.