[SuperSickBoy]

I ripped out my seats and interior cuz I had a hunch about my floors. I was right!! On the passenger side there is a nice size hole that I can see the ground through. I think I could get away with cutting a piece of sheet metal to fit and welding the hole up, but I haven't punched the complete hole out yet. I am not sure how big it will get when I sand everything down to primer it. If this hole grows durring the quest for good metal, is there anyone who makes floor pans that fit a 56 olds? I guess its about time I learn to weld huh? hahahahahaha, this is going to be intertesting!! On the same note, I am almost ready to start sanding down the entire car. Just a few dash chrome left to take out and then it begins. Anyone have some advice to make this go smoothly? What type of sander is the best to use? what grit sand paper should I start and finish with? I know of some really good primer but I am looking for advice from someone who has done this before. I want to use white and black primer. Basically, can anyone give me a sort of "walk through" on the proccess? I was also curious about the outside chrome that goes along the window edges. This metal seems very flimsy and if I pull it I don't believe I will be able to use it again. How has this been replaced by you guys? Wow, I didn't intend for this post to be so long. lol. Thanks for all of you that read the whole thing!!