1955 hood lip for olds 88
I need to purchase a hood lip for a 1955 Olds 88 or 98. email me at chromano@astound.net Thanks, Chuck
lip
is the lip still available? i'm looking for one also. switchblade_pinups@yahoo.com if you still have it~
This is a very old thread but I may end up with an extra after the replacement hood is installed. The one on my damaged hood is perfect but I don't know what the condition of the new hood is, I've only seen pictures, but the best one is going on my car if the other one is usable I will let you know...Tedd
Sounds very high to me, I would think $500- 600 for the whole hood.My new hood is in at the body shop as we speak(write) if you can hold off till Monday evening I will look at it and see if the one on it is usable or even there. I only bought the sheet metal,bare hood,but the picture of it before I bought it showed it with trim on it, they might have left everything together.... Tedd
yea i can hold off. just let me know, the guy originally had some crappy piece made to mimick it but it sits too low. Just let me know! My hood is about to go to the shop. It sits kinda wonky. passenger side of the hood at the rear kinda sticks up. When it closes it hits the driver side in the front then sits down. Hope it just needs to be adjusted!
Sounds very high to me, I would think $500- 600 for the whole hood.My new hood is in at the body shop as we speak(write) if you can hold off till Monday evening I will look at it and see if the one on it is usable or even there. I only bought the sheet metal,bare hood,but the picture of it before I bought it showed it with trim on it, they might have left everything together.... Tedd
yea i can hold off. just let me know, the guy originally had some crappy piece made to mimick it but it sits too low. Just let me know! My hood is about to go to the shop. It sits kinda wonky. passenger side of the hood at the rear kinda sticks up. When it closes it hits the driver side in the front then sits down. Hope it just needs to be adjusted!
Have you tried Big M vintage car parts? John had two hoods that were bent up but I didn't ask about condition of the hood lips, You never know ...Tedd
Big M 530-473-2225
PS if the (wonkyness) is not a weak spring some of it can be adjusted out from inside of the driver's compartment(both sides ) where the hing bracket to cowl bolts are located. This adjustment is best done if the springs are not attached.
I thought my hood was bent as one corner stuck up a bit when the hood as closed. After looking at it, I notice several spot welds broke around the hood hinge area allowing the hood to spring up a little. I was able to squeeze it back in place with clamps and weld it up.
Joe
Joe
Thread
Thread Starter
Forum
Replies
Last Post
Sgt17
The Newbie Forum
3
Jan 26, 2014 07:53 AM



