Homemade GM Th trannytool
#1
Homemade GM Th trannytool
Since i found only expencive tools for engine stands or tablestands for turning the tranny and work easy with it i deside to make a own one i can easy bolt on the main plate for a engine stand...
#2
Nice job! I made a "belly tee" for removing that clutch pack that's way in the rear of some automatics. No where near as fancy as yours! It was just 2 2x4's made into a tee with a notch at the bottom of the tee. Use my big belly to push down on clutch pack and remove clip with snap ring pliers. Pretty crude but worked!
#3
Nice work. That's all the expensive ones are - a "U" shaped frame with pins and clamp screws. I got lucky and found my Kent Moore tool at a swap meet for reasonable bucks (plus, I collect tools like that), but your home brew version is more than adequate.
#4
Thanks, late update,,but it was painted aswell, and now ready to use..will test it soon,, been busy building garage,workbench and a tranny "corner" work Place. I try to hang on it With my 80kilos and it feels solid..lol
Last edited by Oldsragger; December 7th, 2018 at 01:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post