'65 442 Air Cleaner Issues
#1
'65 442 Air Cleaner Issues
About a year ago I replaced the stock 4GC (not original dammit and it was giving me fits) with a Street Demon. Very nice carb, minor install mods and easy to tune.
The issue is with the '65 air cleaner base. The 4GC has a smaller throat size than the later Q-Jets, Holleys, Demon"s, etc. The aftermarket base I used is 1 1/2" smaller in OD than the lid. Consequently there is more engine heat going down the carb than I would like. Been running it this way for over a year with no real issues, but would like to somehow seal it up for a cooler intake air temp and better suck for the blow-by gasses.
Is there a base out there that has the Q-Jet throat size that will fit the original '65 442 lid which has a (EDIT) 17 5/8" OD and correct size filter?
Thanks.............Steve
The issue is with the '65 air cleaner base. The 4GC has a smaller throat size than the later Q-Jets, Holleys, Demon"s, etc. The aftermarket base I used is 1 1/2" smaller in OD than the lid. Consequently there is more engine heat going down the carb than I would like. Been running it this way for over a year with no real issues, but would like to somehow seal it up for a cooler intake air temp and better suck for the blow-by gasses.
Is there a base out there that has the Q-Jet throat size that will fit the original '65 442 lid which has a (EDIT) 17 5/8" OD and correct size filter?
Thanks.............Steve
Last edited by 777stickman; May 14th, 2016 at 02:53 PM.
#4
#6
Not going to modify the original base just because it's original. If I did try that I'd probably need some of the suitable explosives you mention!! The ring thing maybe my only other option if I can't find a suitable base...............Thanks
Last edited by 777stickman; May 14th, 2016 at 03:21 PM.
#7
Can someone measure the bottom OD of their 66--67 442 chrome single snorkel air cleaner lid for me?
My 65 lid OD is 17 1/2" and the base OD is 17 5/8". Just need to know for sure if a 66--67 442 base will work for my project in the original thread.
Thanks............Steve
My 65 lid OD is 17 1/2" and the base OD is 17 5/8". Just need to know for sure if a 66--67 442 base will work for my project in the original thread.
Thanks............Steve
#9
Again.........THANK YOU!!!
Last edited by 777stickman; June 1st, 2016 at 04:23 PM.
#11
I'll probably get reamed for this, but. I'm pretty sure all 65's had the snorkel. I think the open air cleaner came to be with the 67 4 speed, although my Fremont built 67 442 4 speed came with a snorkel??
Thread
Thread Starter
Forum
Replies
Last Post
BeenThere
Parts For Sale
3
September 20th, 2015 07:47 AM
69CutlassAlex
General Discussion
7
December 2nd, 2011 08:01 AM