ClassicOldsmobile.com - Search Results

 
Search: Posts Made By: oldsguybry
Showing results 1 to 40 of 500
Search took 0.14 seconds.
April 18th, 2019, 05:00 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

I put a new accelerator pump in but it still...

I put a new accelerator pump in but it still hesitates . I'll have to mess around with the carb a bit more and get it tuned properly eventually after a rebuild . Right now I'm more concerned with...
March 19th, 2019, 07:07 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

Thanks , I'm going to check the pump first . It...

Thanks , I'm going to check the pump first . It has the neoprene seal instead of the leather one . No matter what tinkering I did on this carburetor it still has this hesitation , but only under load...
March 18th, 2019, 06:27 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

Can anyone tell me what brass dishes shown in the...

Can anyone tell me what brass dishes shown in the picture I posted are ? Would this contribute to the hesitation that I'm getting ?
March 13th, 2019, 10:03 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

yes , I thought about that also . I messed around...

yes , I thought about that also . I messed around with the air gas mixture screws so its probably way out of tune
March 13th, 2019, 08:17 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

I had this carburetor apart and soaked / cleaned...

I had this carburetor apart and soaked / cleaned everything decent last year , It didn't fix the hesitation . I installed all new gaskets
March 13th, 2019, 08:14 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

https://cimg7.ibsrv.net/gimg/classicoldsmobile.com...

https://cimg7.ibsrv.net/gimg/classicoldsmobile.com-vbulletin/760x760/1552489887639_php6j3dd9am_d256f337b8f69435983ecabe5cb5772e35cacf8e.jpg

Maybe this is the issue ?
March 13th, 2019, 07:59 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

https://cimg9.ibsrv.net/gimg/classicoldsmobile.com...

https://cimg9.ibsrv.net/gimg/classicoldsmobile.com-vbulletin/800x450/1552488170978_20190313_092218_1552488074_58452_1bc04505dad1862a1d43751cc6cda1986c9f30a0.jpg

IDK , I can't see anymore.... the...
February 26th, 2019, 02:57 PM
Replies: 23
Views: 1,058
Posted By oldsguybry

Sorry for late reply , I'm going to do some...

Sorry for late reply , I'm going to do some research and get back here to answer shortly
February 11th, 2019, 07:45 AM
Replies: 23
Views: 1,058
Posted By oldsguybry

Where to get a new carb from

I have a 68 Olds Toro 455 in my 72 Cutlass Supreme . Can I get a remanufactured Quadrajet for it or do I need to replace the intake also ? I noticed that Summit has some 750 - 800 CFM carbs but they...
April 1st, 2018, 08:30 AM
Replies: 7
Views: 297
Posted By oldsguybry

https://classicoldsmobile.com/forums/attachment.ph...

https://classicoldsmobile.com/forums/attachment.php?attachmentid=203424&stc=1&d=1522596616
March 31st, 2018, 07:17 AM
Replies: 7
Views: 297
Posted By oldsguybry

I have no idea what most any of this stuff is...

I have no idea what most any of this stuff is worth , please work with me on this ... I'm located near Milwaukee Wisconsin
March 31st, 2018, 07:15 AM
Replies: 7
Views: 297
Posted By oldsguybry

Lastly

76 Olds 350 , needs rebuild .... motor sold
https://classicoldsmobile.com/forums/attachment.php?attachmentid=203381&stc=1&d=1522505667

68 Toro Back Seat Upper $20 ?...
March 31st, 2018, 07:13 AM
Replies: 7
Views: 297
Posted By oldsguybry

More

Each part $5 ? Some 71 CS Parts Here Also .. back up lights and rear bumper lenses sold
https://classicoldsmobile.com/forums/attachment.php?attachmentid=203377&stc=1&d=1522505285

Again $5 ?...
March 31st, 2018, 07:06 AM
Replies: 7
Views: 297
Posted By oldsguybry

68 Toronado parts and misc parts for sale

I'm going to take the bigger parts to the scrap yard this spring finally , so everything must go .... Prefer local pick up , but can work something out to help Olds brothers on here ....


Each...
Forum: Big Blocks
March 31st, 2018, 06:43 AM
Replies: 14
Views: 682
Posted By oldsguybry

Yeah that's what I was thinking :D . I'm hoping...

Yeah that's what I was thinking :D . I'm hoping for cold weather here now so I can enjoy my heater ...
Forum: Big Blocks
March 29th, 2018, 04:10 AM
Replies: 14
Views: 682
Posted By oldsguybry

Thanks everyone for the input on this , it turns...

Thanks everyone for the input on this , it turns out that it was the heater valve . I took the old one off the 350 , put a adaptor on it , hooked all the hoses up and it works now . :D
March 26th, 2018, 10:34 AM
Replies: 25
Views: 2,290
Posted By oldsguybry

Congrats , I can't believe it took this long to...

Congrats , I can't believe it took this long to sell
Forum: Big Blocks
March 26th, 2018, 10:33 AM
Replies: 14
Views: 682
Posted By oldsguybry

:eek: Thanks for that ... that could very well be...

:eek: Thanks for that ... that could very well be the issue .
Forum: Big Blocks
March 25th, 2018, 10:49 AM
Replies: 14
Views: 682
Posted By oldsguybry

I'm hoping I did . I usually order parts under 68...

I'm hoping I did . I usually order parts under 68 Toro 455 when it's motor related and 72 CS 350 when it's anything else ... I'm checking all the vacuum lines first , then I'm going to order a new...
Forum: Big Blocks
March 20th, 2018, 06:30 AM
Replies: 14
Views: 682
Posted By oldsguybry

I wish I could remember if I used heater at all...

I wish I could remember if I used heater at all after putting different engine in car . I took the entire heating / AC unit out from under the hood soon after installing engine because of limited...
Forum: Big Blocks
March 20th, 2018, 04:49 AM
Replies: 14
Views: 682
Posted By oldsguybry

Where or what is this HVAC control head you speak...

Where or what is this HVAC control head you speak of ? The water valve is new , I put it on when I installed engine because the other one came apart where it's fitted together ... I can take some...
Forum: Big Blocks
March 19th, 2018, 03:21 PM
Replies: 14
Views: 682
Posted By oldsguybry

Heater Issue

Ok , my heater blows cold air , I replaced thermostat ... that wasn't the problem . If I flip the selector from cold to hot a few times I get heat for 10 seconds then it goes cold again.... it...
Forum: Big Blocks
March 13th, 2018, 04:36 AM
Replies: 16
Views: 710
Posted By oldsguybry

I suspect Mr. Trip Dueces is correct on the choke...

I suspect Mr. Trip Dueces is correct on the choke adjustment .... the engine runs absolutely fabulous now , except for the bog. It's only there after engine us warmed up .
Forum: Big Blocks
March 13th, 2018, 04:32 AM
Replies: 16
Views: 710
Posted By oldsguybry

Thanks, this will be a big help . I will post...

Thanks, this will be a big help . I will post some pictures later .
Forum: Big Blocks
March 12th, 2018, 03:01 PM
Replies: 16
Views: 710
Posted By oldsguybry

Yeah I found and fixed the problem on why I...

Yeah I found and fixed the problem on why I started the thread , BUT there's still issues though .... I changed the idle as low as it would go and was adjusting the gas air screws to the highest RPM...
Forum: Big Blocks
March 12th, 2018, 06:38 AM
Replies: 16
Views: 710
Posted By oldsguybry

Ok , I found the problem , one of the plug wires...

Ok , I found the problem , one of the plug wires on the dist cap fit loose . It must of been not getting a good connection , which makes all the sense in the world now .... Don't buy cheap plug wires...
Forum: Big Blocks
March 11th, 2018, 07:25 AM
Replies: 16
Views: 710
Posted By oldsguybry

There's no gas leaking anywhere , so what would I...

There's no gas leaking anywhere , so what would I be looking for ? Just curious .... the locking gas cap is aftermarket , and it fits loose .
Forum: Big Blocks
March 11th, 2018, 07:23 AM
Replies: 16
Views: 710
Posted By oldsguybry

I'll have to Google how to adjust this .

I'll have to Google how to adjust this .
Forum: Big Blocks
March 11th, 2018, 07:21 AM
Replies: 16
Views: 710
Posted By oldsguybry

How does this pump work ? Is there something...

How does this pump work ? Is there something hidden under the two springs and plunger ? I ask because the springs and plunger appears to be in great shape physically . Do the springs wear out , or...
Forum: Big Blocks
March 11th, 2018, 06:35 AM
Replies: 16
Views: 710
Posted By oldsguybry

LOL , I have a curse in store for his car ......

LOL , I have a curse in store for his car ... I'm sure I won't do anything because it's not the right thing to do , and I don't have proof .
Forum: Big Blocks
March 11th, 2018, 06:33 AM
Replies: 16
Views: 710
Posted By oldsguybry

It doesn't always do this though , the problem is...

It doesn't always do this though , the problem is worse since I've taken carb off and cleaned it / turned air gas screws .... the sputtering / bogging can be intermittent too . It seems to do this...
Forum: Big Blocks
March 10th, 2018, 01:54 PM
Replies: 16
Views: 710
Posted By oldsguybry

Carb Issue , Help Please

Ok , any ideas what would cause the car to all of a sudden not accelerate properly ? What I mean is .... I just touch the gas and it coughs and sputters like there are cylinders not getting gas ,...
March 9th, 2018, 10:52 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

Ok , any ideas what would cause the car to all of...

Ok , any ideas what would cause the car to all of a sudden not accelerate properly ? What I mean is .... I just touch the gas and it coughs and sputters like there are cylinders not getting gas , and...
March 4th, 2018, 08:54 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

Yeah , I pulled off pan and drained .... there...

Yeah , I pulled off pan and drained .... there must of been unreleased pressure in there or something . I came back the next day and had a mess , mainly because I didn't have the drain pan completely...
March 4th, 2018, 06:13 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

Carb Issue

I'm sure this can't be good ....

https://classicoldsmobile.com/forums/attachment.php?attachmentid=202317&stc=1&d=1520172740

...
January 17th, 2018, 05:05 AM
Replies: 97
Views: 5,699
Posted By oldsguybry

Awww , what's wrong with multi-colors ? I like a...

Awww , what's wrong with multi-colors ? I like a lot of colors :D .... Good job , that beast is looking good ...
...
January 15th, 2018, 03:05 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

I do all the work at my moms house .

I do all the work at my moms house .
January 10th, 2018, 07:08 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

More

I added Epoxy Primer , I didn't buy PPG ( too much money ) . I bought Mason Full Poxy product , 2 parts - Activator/Hardener and Epoxy . It sprayed pretty well , It mixes 1-1 and is pretty easy to...
January 10th, 2018, 06:49 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

Body Work

I finally got a little further on the body work , I located most all the low spots and filled them after sanding everything to bare metal ...
...
January 10th, 2018, 06:44 AM
Replies: 175
Views: 13,228
Posted By oldsguybry

Finally Updates

I bought a transmission from a local shop near Milwaukee , It's rated at 500HP / about 500 FPT w/shift kit and mild TQ ....
...
Showing results 1 to 40 of 500
 


 
Forum Jump

Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.