ClassicOldsmobile.com - Search Results

 
Search: Posts Made By: oldcutlass
Showing results 1 to 40 of 500
Search took 0.20 seconds.
Yesterday, 08:06 PM
Replies: 4
Views: 106
Posted By oldcutlass

Welcome to the site, nice score.

Welcome to the site, nice score.
Yesterday, 03:53 PM
Replies: 167
Views: 7,069
Posted By oldcutlass

Glad it all finally got done, the next time will...

Glad it all finally got done, the next time will be easier...
Forum: 442
Yesterday, 09:45 AM
Replies: 1
Views: 175
Posted By oldcutlass

Your noise could be a rocker or an exhaust leak....

Your noise could be a rocker or an exhaust leak. Should be easy to figure out which. Note, Oldsmobile engines have not lash adjustment. For the hoses, they will be rock hard, you may be in that...
Forum: Small Blocks
Yesterday, 09:38 AM
Replies: 32
Views: 1,114
Posted By oldcutlass

Sucks when you have to go through that much...

Sucks when you have to go through that much trouble. With my last header install my passenger side needed all the work to get past the A frame.
Yesterday, 06:03 AM
Replies: 2
Views: 172
Posted By oldcutlass

No performance increase and most people...

No performance increase and most people disconnect the switch. Its a pollution control device that limits vacuum advance until the engine temp starts to run hot and/or the transmission shifts to 3rd.
June 14th, 2019, 03:49 PM
Replies: 10
Views: 523
Posted By oldcutlass

How to post pictures link: ...

How to post pictures link:
https://classicoldsmobile.com/forums/newbie-forum-55/how-post-pictures-images-132664/
June 14th, 2019, 03:46 PM
Replies: 11
Views: 358
Posted By oldcutlass

Most places will not even service a nine year old...

Most places will not even service a nine year old tire. They are probably out of balance and have flat spots if the car had been sitting for a while. I would replace the valves, they are cheap and...
June 14th, 2019, 05:38 AM
Replies: 167
Views: 7,069
Posted By oldcutlass

With weight on the wheels the angle of the eyelet...

With weight on the wheels the angle of the eyelet on the bar would be less severe also.
Forum: The Clubhouse
June 14th, 2019, 04:59 AM
Replies: 10
Views: 329
Posted By oldcutlass

Everything you do when you are younger comes back...

Everything you do when you are younger comes back to haunt you, I have major tinnitus and severe loss of hearing. For me hearing aides are a blessing and a curse. I've had Resound LINX2 for the...
June 13th, 2019, 07:33 PM
Replies: 167
Views: 7,069
Posted By oldcutlass

It may not be so close to the idler arm once...

It may not be so close to the idler arm once there is weight on the wheels.
June 13th, 2019, 07:31 PM
Replies: 15
Views: 459
Posted By oldcutlass

Thanks for sharing. Someone got a bit carried...

Thanks for sharing. Someone got a bit carried away with the bondo.
Forum: The Clubhouse
June 13th, 2019, 07:20 PM
Replies: 10
Views: 590
Posted By oldcutlass

No where is perfect, moves are very stressful....

No where is perfect, moves are very stressful. Just do your due diligence. We just moved from North Texas to Eastern Oklahoma where the cost of living is on paper cheaper. Time will tell. Very pretty...
June 13th, 2019, 07:13 PM
Replies: 167
Views: 7,069
Posted By oldcutlass

Are the nuts galled on the threaded part? Is the...

Are the nuts galled on the threaded part? Is the sway bar centered in the rubber mounts on the frame?
June 13th, 2019, 04:58 PM
Replies: 2
Views: 311
Posted By oldcutlass

This car has been for sale for a number of years...

This car has been for sale for a number of years now, we've discussed it before. Its not the only one....
Forum: In Memoriam
June 13th, 2019, 02:53 PM
Replies: 8
Views: 331
Posted By oldcutlass

Thanks for providing the correct link Adam. ...

Thanks for providing the correct link Adam. Multitaskin again.
Forum: In Memoriam
June 13th, 2019, 02:36 PM
Replies: 8
Views: 331
Posted By oldcutlass

Another Talent lost - Gascoop

Sorry to hear of the passing of another talented member of our group, RIP Gascoop. Here is link to the project a lot of us were following....
June 13th, 2019, 02:33 PM
Replies: 5
Views: 296
Posted By oldcutlass

Welcome to the site, sorry for your loss. Due to...

Welcome to the site, sorry for your loss. Due to circumstances as an exception to forum rules, I edited your post and added the link to the classified ad. I/we were following his building an Olds...
June 13th, 2019, 02:04 PM
Replies: 6
Views: 469
Posted By oldcutlass

From the installation instructions: • GASKETS...

From the installation instructions:
• GASKETS AND SEALANT 1. Use only Fel-Pro Valley Pan gasket #MS96027 or OEM equivalent when installing Edelbrock manifolds for street applications. 3. Eliminate...
June 13th, 2019, 09:26 AM
Replies: 15
Views: 459
Posted By oldcutlass

Welcome to the site, look forward to some pics.

Welcome to the site, look forward to some pics.
June 13th, 2019, 05:36 AM
Replies: 167
Views: 7,069
Posted By oldcutlass

I don't understand what your looking at?

I don't understand what your looking at?
June 12th, 2019, 08:04 PM
Replies: 167
Views: 7,069
Posted By oldcutlass

No, the load comes when the body rolls. There is...

No, the load comes when the body rolls. There is no load when the car is level.
Forum: Big Blocks
June 12th, 2019, 06:45 PM
Replies: 3
Views: 373
Posted By oldcutlass

Is your radiator hose collapsing? If not, then...

Is your radiator hose collapsing? If not, then no.
June 12th, 2019, 06:35 PM
Replies: 2
Views: 252
Posted By oldcutlass

You will notice a few drops of oil sometimes as...

You will notice a few drops of oil sometimes as the grease separates or moisture gets in there. I think the boots are crumpled differently giving you an optical illusion on the ball joints. You can...
June 12th, 2019, 06:29 PM
Replies: 167
Views: 7,069
Posted By oldcutlass

Your sway bar end link in pic is not tightened up.

Your sway bar end link in pic is not tightened up.
Forum: Transmission
June 12th, 2019, 03:32 PM
Replies: 9
Views: 279
Posted By oldcutlass

Basically use a 1/4 drive ratchet tighten till...

Basically use a 1/4 drive ratchet tighten till snug and then a little. If it weeps, tighten another 1/4 turn until it stops. Try to get them all so that they are somewhat even, as stated above 6-10...
Forum: Other
June 12th, 2019, 01:36 PM
Replies: 12
Views: 361
Posted By oldcutlass

Jaunty was pretty thorough on his search, his...

Jaunty was pretty thorough on his search, his suggestion is from personal experience.
June 12th, 2019, 01:31 PM
Replies: 17
Views: 700
Posted By oldcutlass

Basically what most of us do. I will add that...

Basically what most of us do. I will add that the carb bowl should not be empty sitting for a week or so.
Forum: Transmission
June 12th, 2019, 01:28 PM
Replies: 9
Views: 279
Posted By oldcutlass

Yes to the magnet and 10 ft lbs of torque.

Yes to the magnet and 10 ft lbs of torque.
Forum: Other
June 12th, 2019, 01:25 PM
Replies: 12
Views: 361
Posted By oldcutlass

Yes your crazy if the tank is in good shape. ...

Yes your crazy if the tank is in good shape. Drop it and see whats going on with your float.
June 12th, 2019, 05:17 AM
Replies: 167
Views: 7,069
Posted By oldcutlass

I prefer going to discount tire or a local tire...

I prefer going to discount tire or a local tire store. Most will match the online pricing and I don't have to jump through hoops for a defect
June 11th, 2019, 07:46 PM
Replies: 9
Views: 471
Posted By oldcutlass

Welcome to the site, I moved your post to the...

Welcome to the site, I moved your post to the newbie section.
June 11th, 2019, 07:43 PM
Replies: 167
Views: 7,069
Posted By oldcutlass

Generally tires play little role in front end...

Generally tires play little role in front end alignment requirements unless you change wheels or tire sizes. If it drives straight and there are no tire wear issues a new alignment is not required.
June 11th, 2019, 07:36 PM
Replies: 10
Views: 523
Posted By oldcutlass

Welcome to the site. I suggest some pictures to...

Welcome to the site. I suggest some pictures to start.
Forum: Big Blocks
June 11th, 2019, 03:38 PM
Replies: 9
Views: 521
Posted By oldcutlass

Oldsmobile distributors turn CCW, so once you...

Oldsmobile distributors turn CCW, so once you establish #1 wire the firing order from there.
June 10th, 2019, 06:05 PM
Replies: 19
Views: 748
Posted By oldcutlass

Welcome and congrats.

Welcome and congrats.
June 10th, 2019, 02:16 PM
Replies: 18
Views: 1,069
Posted By oldcutlass

You may need to get used to what the car wants to...

You may need to get used to what the car wants to get it going. While chatter can be caused by an oil leak contaminating the disc, not adjusted properly, a bad pressure plate, burnt flywheel, or as...
Forum: 442
June 10th, 2019, 02:11 PM
Replies: 7
Views: 450
Posted By oldcutlass

Without pictures its tough. From what you...

Without pictures its tough. From what you described, maybe $1200.
June 9th, 2019, 05:15 AM
Replies: 6
Views: 603
Posted By oldcutlass

Welcome to the site, Whats your plan for it?

Welcome to the site, Whats your plan for it?
June 8th, 2019, 09:50 PM
Replies: 10
Views: 829
Posted By oldcutlass

Have you popped it open? The axles on those cars...

Have you popped it open? The axles on those cars are really weak.
Forum: Small Blocks
June 8th, 2019, 08:51 PM
Replies: 19
Views: 756
Posted By oldcutlass

This is what I thought that was on there by the...

This is what I thought that was on there by the picture, some use these in leu of the turkey tray. My bad, missed the part where the gasket was long gone. You can go either way using another steel...
Showing results 1 to 40 of 500
 


 
Forum Jump

Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.