old olds backing plates
#7
OK, I dug them out this morning and my (rough) measurements were:
13" overall diameter
center bore 3-1/4" ID
top bolt holes 3-1/2" center-to-center
bottom bolt holes 2-9/16" c-to-c
Sorry the pics are a bit blurry, but my camera doesn't like to autofocus at close range
They're pretty dirty and show some rust pitting, but are solid and usable. They'd look a lot nicer if sandblasted and painted.
13" overall diameter
center bore 3-1/4" ID
top bolt holes 3-1/2" center-to-center
bottom bolt holes 2-9/16" c-to-c
Sorry the pics are a bit blurry, but my camera doesn't like to autofocus at close range
They're pretty dirty and show some rust pitting, but are solid and usable. They'd look a lot nicer if sandblasted and painted.
#10
I've got this pair. Came from a '64 full-size Pontiac, is the right bolt spacing. They look a little crusty and could use a good blasting, but are solid. Not sure where the brake hardware is for one of 'em. $35 for the pair plus the shipping.
Thread
Thread Starter
Forum
Replies
Last Post
oldzy
Brakes/Hydraulic Systems
8
October 5th, 2010 03:39 PM