1970 Floor,Firewall,Trunk, Original Rust Free Parts
#1
Registered User
Thread Starter
Join Date: Oct 2011
Location: Glendale and Sierra Vista,Az
Posts: 599
1970 Floor,Firewall,Trunk, Original Rust Free Parts
I bought this 1970 Monte from one of my old customer, it had been damaged on both quarters so it will be a donor and the parts listed are the same as your 70 Cutlass. It will be at my storage lot in 2 weeks to be disassembled mostly by spot welds. Full floor pan(tech 70 only but same as 68-72 if your not being judged), was bench seat and has the center brace like the convertible with a bolted frame mount, other coupes used blanks (under the door), price is $500.00 from front seam to rear seam where it meets the trunk pan/divider panel, taken off the spot welds. Full firewall (heater)with side shoulders, door jambs were door hinges mounts to, cowl gutter (under top cowl) larger torque boxes (like most convertibles)including the lower mounting ledges for the fenders $600.00 or with floor pan for $1000.00 and will include the full inner and outer rockers. If you like full 70 trunk pan(other years are different in the middle above the rearend). I cut the very back tail panel off just above the frame mounting brace, where all the GM models change, about 3 inches higher then the 4 main support braces (gas tank straps to the 2 of the them) Price would be 325.00 (300.00 extra to full floor pan and firewall sale) Sold this same set up 3 times before and each were for ragtops, very please customers who said it saved them lots of time and money. Shipping will be with UShip it unless you want to pick it up, 60 miles southeast of Tucson, invoice from Paypal as a sale for the part, then once its ready ,I can give you all the quotes. The last one as the full floor with trunk to NY was 760.00, about 2 years ago. The trunk pan would have to be removed where it meets the floor pan for shipping. The other parts too like the trunk divider panel $125.00 ,inner quarter panel to floor braces 150.00 pair, top cowl which is the same up to the windshield channel but yours has the metal top dash area this ones doesn't, good for repair the exterior rust in that area $140.00. Also full A pillars for $175.00 pair, cut out nicely with good channels. Here are some pics I have on my computer at this time. Joe 602-298-7090
Last edited by AzChevs; September 10th, 2018 at 02:26 PM.
#3
Registered User
Thread Starter
Join Date: Oct 2011
Location: Glendale and Sierra Vista,Az
Posts: 599
It was 2 cars I was buying thinking the 70 was the parts car and the 71 was a show car that was hit in the front but restorable. It turned out being the other way around, the 71 is the parts car and it had bucket seats. Are you wanting an exact 70 only pan? This 71 only had 2 tiny spots of rust in the front curve of the toe board one on each side, car was sitting with the rear up and no windshield with trash build up. Super minor, I actually made the holes while scraping those areas.
#5
Registered User
Thread Starter
Join Date: Oct 2011
Location: Glendale and Sierra Vista,Az
Posts: 599
Thread
Thread Starter
Forum
Replies
Last Post
AzChevs
Parts For Sale
0
July 18th, 2014 10:09 AM
AzChevs
Parts For Sale
2
June 23rd, 2014 11:52 AM