Sun Mini Tach mounted in '70-2 Cutlass, etc factory clock blank
#1
Sun Mini Tach mounted in '70-2 Cutlass, etc factory clock blank
EDIT: Sale pending
Sun Mini Tach mounted in a factory clock "blank".
>Tach is tested and it works
>Wiring intact and labeled - one wire may need some additional length added to it (white wire for lighting)
>This will fit into the right side "clock" opening on a '70-2 Cutlass, etc
$35 + shipping.
Pay by check or MO....no paypal.
If you need a Gas Tank Pad this tach will easily fit inside the same package/box....save some on shipping. Gas Tank Pad link below my sig.
Sun Mini Tach mounted in a factory clock "blank".
>Tach is tested and it works
>Wiring intact and labeled - one wire may need some additional length added to it (white wire for lighting)
>This will fit into the right side "clock" opening on a '70-2 Cutlass, etc
$35 + shipping.
Pay by check or MO....no paypal.
If you need a Gas Tank Pad this tach will easily fit inside the same package/box....save some on shipping. Gas Tank Pad link below my sig.
Last edited by 70Post; March 26th, 2017 at 01:28 PM.
#3
I have sold MANY MANY parts to folks on here and other Abody sites and NOT ONCE has a check been lost or not shown up in the mail.
While I appreciate your concern about the mail system, my experience with it has been 100% reliable.
While I appreciate your concern about the mail system, my experience with it has been 100% reliable.
#4
How much shipped to 74008? There's a first time for everything I suppose.
#5
Sale pending
$40 total cost....I'll cover any difference in shipping. This is just an "extra" part I am not going to need.
I'll PM you with my mailing address.
EDIT: Just sent you a PM....Thanks
$40 total cost....I'll cover any difference in shipping. This is just an "extra" part I am not going to need.
I'll PM you with my mailing address.
EDIT: Just sent you a PM....Thanks
Last edited by 70Post; March 26th, 2017 at 01:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
RAMBOW
Major Builds & Projects
17
May 3rd, 2022 04:25 PM
RAMBOW
General Discussion
7
July 26th, 2011 07:28 PM