Anti-hop bars
#2
Hi
I'm Interested
Will these require me cutting / grinding / or drilling my 69 type "O" rear differential ?
Is it a simple install or more than simple / like it would be easier to remove the rear end for install ?
Thx
C
I'm Interested
Will these require me cutting / grinding / or drilling my 69 type "O" rear differential ?
Is it a simple install or more than simple / like it would be easier to remove the rear end for install ?
Thx
C
#4
Bars
Hi
I'm Interested
Will these require me cutting / grinding / or drilling my 69 type "O" rear differential ?
Is it a simple install or more than simple / like it would be easier to remove the rear end for install ?
Drill the webs on housing on each side of pinion. 3/8 holes I helieve
Thx
C
I'm Interested
Will these require me cutting / grinding / or drilling my 69 type "O" rear differential ?
Is it a simple install or more than simple / like it would be easier to remove the rear end for install ?
Drill the webs on housing on each side of pinion. 3/8 holes I helieve
Thx
C
#7
#9
The upper control arms are still used; the control arm attaches to the bushing on the end. These raise the control arm mounting point, which then changes the "instant center" of the rear suspension.
Below are pictures of one of my O-Types that the previous owner installed no-hop bars. You can see the small hole drilled into the lower webbing on each side.
Below are pictures of one of my O-Types that the previous owner installed no-hop bars. You can see the small hole drilled into the lower webbing on each side.
Last edited by Fun71; November 6th, 2022 at 08:43 AM.
Thread
Thread Starter
Forum
Replies
Last Post