350 for sale
#1
350 for sale
Got a olds 350 for sale it is bored 30 over high compresion pistons,224/234 duration @.050 lift 496/520 lift 112 lobe seperation cam, edelbrock performer intake, and 750 edelbrock carb. It has chrome valve covers and air cleaner. It has number 8 heads,it was out of a 72 or so I was told. It has less than 15k since rebuild. It is still in the car if you want to hear it run so let me know as I may be pulling it this weekend if I get my 455 together. Make me an offer. Either PM me or post on here I will try to check back daily. I live about 1/2 hour west of clevland. Thanks Darin
#3
Previous owner had it rebuilt so this is all I can tell you. It runs very strong and pulls hard even with crap rear end gears. The car and engine were built some place in CT. I was told the pistons are forged dome high compression I don't know the brand.
#4
pull the spark plug,on #1 cylinder,work the piston around to the top.
you can shine light into the cylinder,and i bet youll be able to see what the over bore was on the piston,and whether it has a dish in the top of the piston.
when trying to sell a motor,its kind of important to know what's in it.
you can shine light into the cylinder,and i bet youll be able to see what the over bore was on the piston,and whether it has a dish in the top of the piston.
when trying to sell a motor,its kind of important to know what's in it.
#5
I looked in the cylinder and the pistons look the same as the ones in my 455 so I dont know what they are you are more than welcome to check it out if you like I will probably have it pulled out by the end of next weekend.
#7
whats the engine casting number above water and to the right of the oil filler tube. how much are you asking.
I would like to get 1000 out of it I know I have seen them on ebay for way more and I know what it cost to build a motor as I have just finished putting my 455 together today
Make an offer or come and have a look because I will be pulling it probably next weekend if you want to hear it run
Thread
Thread Starter
Forum
Replies
Last Post
cutlassKing
Parts For Sale
5
November 29th, 2010 03:05 PM