stalling issue
#1
stalling issue
I have a 1976 Cutlass with a 260. After driving, I'll go to back it in to a parking spot and it stalls everytime. I took the a/c belt off because the compressor is bad. That wasn't it. Had my carb rebuilt, but that did nothing as well. I'm at a loss.
The newer cars have a cut off switch, does a 76 have one? I would guess not, but not sure.
The newer cars have a cut off switch, does a 76 have one? I would guess not, but not sure.
#2
Does it stall in reverse only? Try putting it into neutral and then back into drive instead of reverse to see if it stalls.
Is the stalling very sudden/abrupt or does it give some warning and stall over a few seconds?
This would not be reverse only but the EGR valve could be sticking open causing a vacuum leak.
Cut-off switch...no, not equipped.
Good luck!!!
Is the stalling very sudden/abrupt or does it give some warning and stall over a few seconds?
This would not be reverse only but the EGR valve could be sticking open causing a vacuum leak.
Cut-off switch...no, not equipped.
Good luck!!!
Thread
Thread Starter
Forum
Replies
Last Post