Repop door hinges
#1
Repop door hinges
Hey guys:
I planned to buy the pin & bushing kits to rebuild my door hinges, but my lower hinges are rusted beyond repair. The pin that holds the detent springs has rusted away and the springs are missing as well. I see several suppliers repop the door hinges for around $60-$70 bucks.
1. Are the repop hinges any good?
2. Which vendor sells the best parts?
3. Some vendors state their parts are stamped from new tooling. Is there are truth to that statement or just marketing BS?
4. Should I look for some good used ones and install the bushing kits?
Thanks!
I planned to buy the pin & bushing kits to rebuild my door hinges, but my lower hinges are rusted beyond repair. The pin that holds the detent springs has rusted away and the springs are missing as well. I see several suppliers repop the door hinges for around $60-$70 bucks.
1. Are the repop hinges any good?
2. Which vendor sells the best parts?
3. Some vendors state their parts are stamped from new tooling. Is there are truth to that statement or just marketing BS?
4. Should I look for some good used ones and install the bushing kits?
Thanks!
Last edited by cdrod; June 13th, 2017 at 04:41 PM.
#3
I bought a repop set and wasn't pleased, so went back to the originals. The hold open lever is made differently - there's no intermediate position and it doesn't hold very well at the full open position. Something else was wrong, but it's been too long.
When rebuilding originals, remember to oil the hold open lever mount. It'll squeak and will likely be loose from age - no replacements. No usability problems with that being loose, other than it'll squeak. Took me way too long to realize that was the problem.
When rebuilding originals, remember to oil the hold open lever mount. It'll squeak and will likely be loose from age - no replacements. No usability problems with that being loose, other than it'll squeak. Took me way too long to realize that was the problem.
Thread
Thread Starter
Forum
Replies
Last Post
jensenracing77
General Discussion
6
November 11th, 2016 09:08 AM