water pump bolts
#2
The self-tapping screws are 1/4-20. Note the two special bolts with studs on the heads (one 5/16 and one 3/8) for non-A/C cars. With A/C there was an additional 5/16 bolt with a stud on the passenger side.
#4
Bruce, let me know which ones you need and I can send them on with the alt brackets for a few bucks more. Standing by.....Let me know....We have had conversations about parts in the past but never have followed through with anything yet... Am I the only one?
Yeah, Yeah. I have been drinking again and my GAF has been bent for a while.
Tired is as tired does, lol.
Yeah, Yeah. I have been drinking again and my GAF has been bent for a while.
Tired is as tired does, lol.
Last edited by tru-blue 442; April 26th, 2017 at 12:27 PM.
#6
Thanks for this post Joe... this saved my butt.. the factory 1979 Oldsmobile Service Manual does not have this Figure. It has very misleading and lack of info on this.. In the '79 manual engine torque list it says 13lbs. in the cooling section is says 22lbs, OK '69 spec was 25lbs. Yes but what bolts????? no figure in it..
Fred
Fred
#7
Thanks for this post Joe... this saved my butt.. the factory 1979 Oldsmobile Service Manual does not have this Figure. It has very misleading and lack of info on this.. In the '79 manual engine torque list it says 13lbs. in the cooling section is says 22lbs, OK '69 spec was 25lbs. Yes but what bolts????? no figure in it..
Fred
Fred
Thread
Thread Starter
Forum
Replies
Last Post
Al Sanchez
General Discussion
7
September 6th, 2013 03:30 PM