venting the gas tank
#1
venting the gas tank
Anyone know anything about venting the gas tank on a 1967 442. The car when we broke it down for resto had 2 lines coming off the tank and one had a hose with a old spark plug shoved in it. Anyone know the correct way to vent it and parts needed to do that job.
Thank you , Bob
Thank you , Bob
#2
There are a couple of kits that work, basically 2 rubber lines and a plastic filter stufffed with cotton. It clamps in behind the bumper above the license plate.
Just scroll down until you see it:
http://www.inlinetube.com/New%20Prod...Oldsmobile.htm
Just scroll down until you see it:
http://www.inlinetube.com/New%20Prod...Oldsmobile.htm
#3
That will work well, but I believe the factory setup was a little different in 1967. What I've seen is a chuck of cotton like filter stuffed into the end of the large hose and a plastic plug with a small hole in the center pushed into the small hose.
I wasn't able to get the link to open, but I believe what Oldcutlass is describing was used in 1968-72 and would probably work better than the factory 1967 parts.
John
I wasn't able to get the link to open, but I believe what Oldcutlass is describing was used in 1968-72 and would probably work better than the factory 1967 parts.
John
Thread
Thread Starter
Forum
Replies
Last Post
ah64pilot
Racing and High Performance
19
April 9th, 2012 02:55 PM
Texas442
General Discussion
2
January 30th, 2012 05:36 PM