1961 olds rocker panel mouldings
#2
I don't think you can, most parts for that model will need to be fabricated in-house vs. the dime a doz. cars that mfg's can make money on selling rplacement body parts. Supply and demand.
#4
Mlds.
Try Junkyard Johnny in Pheonix AZ. Haven't got his number handy but his real name is John Rosen and you'll need A lot of Money in your Pocket for any of his stuff.
Last edited by chequenman; January 17th, 2010 at 01:11 PM.
#5
Rocker Panel Moldings
Good luck on the Rocker Panel Moldings. Five years ago one of my car ramps collapsed as I was pulling the car up on it. The opposite ramp kicked out and dented the Rocker Panel Molding. I checked at Carlisle and Hershey. The only ones for sale were much worse than mine. Finally, I took my Cutlass down to Thortons in Telford, Pa. and had the hood repainted in addition to having the dent removed. They did a beautiful job (completely undectable)
Thread
Thread Starter
Forum
Replies
Last Post
CutlassLegend
Small Blocks
2
September 21st, 2011 02:56 PM
guy.graziano
Parts For Sale
0
September 19th, 2010 06:24 PM