Loose control arm screws
#1
Loose control arm screws
So I was getting my alternator and few other issues sorted out on this 64 starfire, and I noticed this. Maybe the picture shows it, the screw that holds the washer and control arm bushing in place is super loose. Like 1/4 out, almost falling out loose. 3 out 4 uppers were like this, the lower all seem ok.
As the car is new to me I don't have the chassis manuals yet. But I know not long before I bought it got new ball joints and bushings.
How tight as these supposed to be? Just snug on the rubber or a torque vale or what? Maybe some loctite?
As the car is new to me I don't have the chassis manuals yet. But I know not long before I bought it got new ball joints and bushings.
How tight as these supposed to be? Just snug on the rubber or a torque vale or what? Maybe some loctite?
Thread
Thread Starter
Forum
Replies
Last Post
oldzy
General Questions
5
December 19th, 2011 06:43 AM
HouTXCutlass
Chassis/Body/Frame
7
March 2nd, 2011 06:16 PM