Manual drum / drum booster addition
September 29th, 2017, 07:14 AM
#1
Registered User
Thread Starter
Join Date: Jul 2008
Location: North West Michigan
Posts: 173
Manual drum / drum booster addition
Good Morning,
I have a manual drum/drum car.
Can I put my own existing manual drum/drum master cylinder on a disc booster?
Will I need any type of proportioning valve? At this time I only have an existing distribution block.
Accidentally purchased Stainless lines to distribution block from master cylinder for power drum/drum application and line input to master cylinder too far from firewall. Do not want to cut lines down as I will convert in future.
I will put a booster on for now if I can use these same lines in the future.
If not, I will just purchase new lines.
I have a manual drum/drum car.
Can I put my own existing manual drum/drum master cylinder on a disc booster?
Will I need any type of proportioning valve? At this time I only have an existing distribution block.
Accidentally purchased Stainless lines to distribution block from master cylinder for power drum/drum application and line input to master cylinder too far from firewall. Do not want to cut lines down as I will convert in future.
I will put a booster on for now if I can use these same lines in the future.
If not, I will just purchase new lines.
Thread
Thread Starter
Forum
Replies
Last Post
zodiacblueS
Brakes/Hydraulic Systems
44
October 12th, 2014 03:22 PM
455Olds
Brakes/Hydraulic Systems
11
December 8th, 2013 08:16 PM
1carsick
Brakes/Hydraulic Systems
23
October 2nd, 2012 05:50 PM
