When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
i am hoping I have this right as I am test fitting and hopefully welding later today. All advice and opinions are welcome from what it look like to me is that the filler panel welds under the trunk pan.
Last edited by armycav0; July 18th, 2017 at 03:23 PM.
It should butt up against the side of the trunk floor and sit flush on top. Then spot welded into place. Here is an example as I was installing in my 69.
It should butt up against the side of the trunk floor and sit flush on top. Then spot welded into place. Here is an example as I was installing in my 69.
thank you for the picture. I would have been all messed up.
Had to do a small repair on the inner wheel well before putting in the trunk pieces. Having problems with the welder, kept blowing through. I am using a craftsman with .30 wire no gas and on setting B3 as it says on the machine.
July 18th, 2017, 08:32 AM
