Cman7713

Hey guys,

Coming up in the next month or so my 69 Cutlass will be up on a buddies lift for a trans rebuild and new torque converter. During that time I am going to have the rear out from drum to drum to install a new one I recently purchased. Basically trans/drive shaft/exhaust/rear end will all be pulled and i'll have pretty much full access to the frame and undercarriage from the engine back. I won't be able to spray in this garage so i'm looking for a quality brush on paint to use after a degrease and prep. Por 15 has been brought up a few times. I'm planning on picking my supplies up at Eastwood since it is down the street from my house.

Thanks,

redoldsman

I would use POR15. I think Eastwood has a similar product. I have used their paints and they are good. Be sure you do not get that stuff on you. Nothing will bring it off.

Cman7713

Thanks for your input Redoldsman, you are now the fourth person to say POR15. It seems to be a no brainer at this point.