FYI, old Olds distributors may cause backfiring...
#1
FYI, old Olds distributors may cause backfiring...
I got my 455 back together last week, and got it in the car and running, but had a mysterious backfire through the carb. Moved the timing all over the place and looked for vacuum leaks to no avail. It ran a little better at 12 BTDC than at 8 or 4, but still backfired. Mostly under light load. We also checked plug wires to make sure they were installed in the right position.
An Olds guru at work told me that high mileage Olds distributors are well know to cause the points to misfire... That didn't occur to me, but makes sense after he told me. The rotor end can wobble around a little when the bushings get worn and that screws up the dwell and/or ignition timing.
I swapped in another used distributor I had and the backfire went away.
Eventually I may buy a remanufactured distributor ($38), or shell out big bucks for an HEI, but for now I'll tool around with this ~72k distributor that still works good.
Hope this info may help someone else too. Applys to small blocks too obviously. Tom.
An Olds guru at work told me that high mileage Olds distributors are well know to cause the points to misfire... That didn't occur to me, but makes sense after he told me. The rotor end can wobble around a little when the bushings get worn and that screws up the dwell and/or ignition timing.
I swapped in another used distributor I had and the backfire went away.
Eventually I may buy a remanufactured distributor ($38), or shell out big bucks for an HEI, but for now I'll tool around with this ~72k distributor that still works good.
Hope this info may help someone else too. Applys to small blocks too obviously. Tom.
#3
Kaboom
I had a serious misfire on my '68 400, right at the traffic lights in town, sounded like a cannon and made me jump..but I had my seat belt on and I was not ejected... turned out to be a broken distributor wire- from coil to points- broken inside the insulation where you couldn't see it...
#5
#6
Is this one any good?
They do reasonable shipping to UK so might get one if you guys think it's a worthwhile upgrade.
http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWAX%3AIT
They do reasonable shipping to UK so might get one if you guys think it's a worthwhile upgrade.
http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWAX%3AIT
#9
#10
I have a very similar problem with my 70. At idle the dwell was jumping all over the place. At part throttle cruising at around 45 and up it would miss like mad. Floor it and it ran like a bat outta hell. It was driving me NUTS.
I had a COMP 9000 that I got cheap so I dropped that in and no more missing.
I'd like to fix it, but I just don't think it's worth it.
I had a COMP 9000 that I got cheap so I dropped that in and no more missing.
I'd like to fix it, but I just don't think it's worth it.
#11
Note that ANY distributor (points or electronic) can suffer from worn bushings. As the bushings wear, timing bounces around, causing performance problems. Bushings can be replaced, fixing the problem.
Thread
Thread Starter
Forum
Replies
Last Post