When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey guys,
I am about at my wits end I’ve had this carburetor
part about six or seven times I’ve went to three rebuild kits
every time I put it back together the Accel pump gasket falls off and get smashed down under the spring and I have no fuel am I putting it together wrong this is exactly how I’m putting it in the carb.
Last edited by JOHNNYOLDS442; March 19th, 2018 at 10:37 AM.
Reason: Spelling
Make sure you work the lip of the seal into the bore before you push down on it, and take care that it doesn't pop out while you're installing the air horn.
will do seems to work until over night .
next morning loose accel pump again rod will not move back up???
Originally Posted by frankr442
Make sure you work the lip of the seal into the bore before you push down on it, and take care that it doesn't pop out while you're installing the air horn.
Piston should move smoothly up and down (with spring tension). Is the lever binding, or maybe a problem with the hole in the air horn causing the piston rod to hang up?
I had this happen twice on my Q-Jet, the third and final repair attempt was a new accelerator pump from Cliffs Q-Jets. Cliff told me the issue is the enthonal in today’s fuels. The piston swells enough for the spring to eventually pull apart. The W-Jet on my car was a Edelbrock 850 that I bought new in a sealed box from a swap meet, the 2 pistons I replaced came from parts store rebuilds. The piston from cliff was installed about 5 years ago, that carb is now on my friends 66 Olds and still going strong
March 19th, 2018, 10:35 AM
