Oil pressure sensor too fat
#1
Oil pressure sensor too fat
I bought a set of electric (not mechanical) Gauges for my 69 cutlass 350. Problem is the oil pressure sensor is too large in diameter to fit. The location of the sensor hole is located too close to the block. I was wondering if I got a 3 inch brass extension to raise it up past the block if that would work? Or would it not read accurate?
#3
#5
I ordered some fittings and adaptors, and ended up with something like this:
About 2" long, 2 female 1/8"-27 NPTF ends, a side 1/8"-27 NPTF hole, and a male to male 1/8"-27 NPTF piece for screwing one end into the block, bought it on eBay.
Your local Harley dealer might be a good source for that kind of 45°/straight brass, steel and copper NPT stuff.
About 2" long, 2 female 1/8"-27 NPTF ends, a side 1/8"-27 NPTF hole, and a male to male 1/8"-27 NPTF piece for screwing one end into the block, bought it on eBay.
Your local Harley dealer might be a good source for that kind of 45°/straight brass, steel and copper NPT stuff.
Last edited by Nop; April 29th, 2014 at 11:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post