FinOldsMan

Hi all.. it been a while i sen messages to here but here i am again

Last time i had this 455 RE85 Projekt so no is ended and running..

so here is what i made it for and what i do...

750DP Holley
Edel Torker 2: Pocket porting
Edel 290/300 .500 .524 camchft
G heads: pocket porting 70cc milling
Sealed power -14cc pistons
comp 12:1
Hi-volume oilpump
Flowtwchin headers whit porting

Then i got it to Dyno!! so i hawn no my dyno on paper but this how it goes....

4500rpm 400hp and 650Nm torque and then Cardan shaft and th350 broke up!! that was going... so now i had th400 and chevy cardanshaft on.. hope that they survive!

so if i go again to Dyno we got 500+ hp on 6000rpm..

oldcutlass

What are you using for fuel over there?

cutlassefi

I get approx 11.0:1, not 12.0:1. Which Speed Pro piston are you using?

FinOldsMan

I think heads are more milled and i use very thin headgasgets. pressue meter shows us 12:1 compression. this engine has cast Sealed power hi-comp pistons.

FinOldsMan

Like it says top of topic RE85 ethanol fuel. Everything is modified for that.

FinOldsMan

As you see 4500Rpm car broke...