'78-'87 G Body manual transmission conversion
#1
'78-'87 G Body manual transmission conversion
I sold my Tremec shifted g body a couple of years ago, and don't think I will need these parts anymore. I did my conversion before aftermarket versions were available, and original parts were about as hard to find as Abody ralley pacs. I picked up every set I found for a few years, and produced this hoard of g-body pedal parts. If your interested in sticking it to your g body, I have most everything you would need. I do not have a BOP bell housing with offset pivot, nor any funky wavy clutch release forks. I do have a very good template for relocating the pivot on a Lakewood style scatter shield. Let me know what you need and I will try to give a reasonable price. As a side note, this conversion was the best modification I had done to my g-body. Lots of fun!
Last edited by Funkwagon455; October 20th, 2013 at 09:09 AM. Reason: Photos
#4
I was intending to price the items based on individual needs.. If you need a set of pedals,frame bracket,pedal stop, z bar, and full setup versus just a set of pedals to go hydraulic. Or maybe someone may be interested in the entire lot.... That is why I asked to send inquiries, so that I could price based on needs.
#7
Well, Alright, A set of original pedals, with z-bar, frame bracket w/ hardware, clutch pedal stop, pedal linkage rod, bell crank to fork rod, neutral safety switch, return spring, block pivot ball, shift boot with frame and firewall boot. All can be yours for the unbelievably low price of just $299.99 plus shipping. The boots are not very nice, but are serviceable and serve well as a go-by for what is correct. The pedals and linkage are in good serviceable condition, just need prettied up.
Last edited by Funkwagon455; December 15th, 2013 at 01:32 PM. Reason: Photo added
#10
I've sold the above listed set which included the shift boot, neutral safety, and firewall boot. Still have another set in good serviceable condition, no cracks or worn out pivot holes. All of the actual parts in the picture below,,,$275 plus shipping. I also have a set of pedals only with a pedal stop for the clutch for anyone interested in a hydraulic option. Thanks for your interest.
#11
I've sold the second complete setup I had today. I have no more Z bars and linkage. I do have one more set of original pedals with the clutch pedal stop bracket available. This would be necessary for those doing a hydraulic clutch setup on G bodied GM products from '78-'87 $75.00 plus the ride to the lower 48 states. Pics on request, Thanks for your interest.
Thread
Thread Starter
Forum
Replies
Last Post
Starfire1961
Parts For Sale
1
November 9th, 2011 08:53 AM
MaxDog
General Discussion
5
July 21st, 2011 11:50 AM
Eightupman
Parts For Sale
0
January 6th, 2010 03:14 AM