1968 and 69 wheel well trim rings
#9
But Dean's not selling trim rings and he knows the difference between 68 & 69
ttt
#10
Should have clarified better far as which part I am selling these are wheel well moldings - sorry for confusion
yes Mike that I do lol.
Tru Blue ty always get stumped when someone says left or right so yes I definitely find it easier when driver or passenger terms are used.
So with that being said - people who do have interest could reference that for my rookie self that would help me ty Dean
yes Mike that I do lol.
Tru Blue ty always get stumped when someone says left or right so yes I definitely find it easier when driver or passenger terms are used.
So with that being said - people who do have interest could reference that for my rookie self that would help me ty Dean
#19
#22
#23
Tomorrow someone is coming to take off all the peak moldings off a parts car. I will watch and then I can tell you. But based on the nature of the design has to be difficult I imagine but don't know for sure. Notice I am having them do it lol.
#25
#26
#32
#34
#35
#37
Left and Right are defined as THE CAR's or "as normally seated in the driver's seat" for most purposes.
The car's Left and Right do not change. The observer's Left and Right do change with the observer's position and orientation. My '68 442 will have the driver on the observer's Right... if the observer is facing backwards from the front of the vehicle... unless they are hanging upside down... So, let's stick with THE CAR's Left and Right.
The only vehicles I can think of this would not be good for would be an asphalt roller, which has no defined "front" or normal direction of travel.
#38
wheel well driver side rear
hello,
I know youre probably busy....but when you get the chance....email me pics.... onofrelopez@sbcglbal.net
thank you,,,
I know youre probably busy....but when you get the chance....email me pics.... onofrelopez@sbcglbal.net
thank you,,,
#39
I am terribly sorry for the delay thought I had another and do not. I do know someone who has them his name is Paul you can rech him at 203-272-7103. I hope he can help Dean
Thread
Thread Starter
Forum
Replies
Last Post
jonn
Parts Wanted
3
November 22nd, 2014 06:36 PM
kbeler
Parts Wanted
5
March 28th, 2013 08:30 PM