#2 heads, stainless valves
#1
#2 heads, stainless valves
#2 bare heads, resurfaced, new hardened exhaust seats, intakes ground and ready to go. Chambers are approximately 64cc. I don't have the world's most precise measuring equipment, but this number should be very close. I measured several times and got the same result each time.
$200+shipping
SI stainless valves for above heads. Brand new. a few taken out of package for inspection but most are still in plastic bags. I believe they are 1.875" intake and 1.562" exhaust.
$125.00 + shipping
I have everything needed to assemble the heads - springs, shims, retainers, valve seals. If you want to purchase the whole package, assembled or not, shoot me an offer via PM or Email jslabotsky(at)yahoo.com
Reason for selling: These heads were originally going to be used on my 1976 350 to bump the compression. I decided to go with a big block instead because I found a great deal on some ported C heads.
I will consider trades. Looking for:
- BBO headers for 76 Cutlass S
- TH200-4R transmission
- 15x8 or 15x10 widened SSIII wheels
- Front and rear lenses for 76 Cutlass S
- Usable 455 bare block
Probably lots of other things.. just hit me up.
$200+shipping
SI stainless valves for above heads. Brand new. a few taken out of package for inspection but most are still in plastic bags. I believe they are 1.875" intake and 1.562" exhaust.
$125.00 + shipping
I have everything needed to assemble the heads - springs, shims, retainers, valve seals. If you want to purchase the whole package, assembled or not, shoot me an offer via PM or Email jslabotsky(at)yahoo.com
Reason for selling: These heads were originally going to be used on my 1976 350 to bump the compression. I decided to go with a big block instead because I found a great deal on some ported C heads.
I will consider trades. Looking for:
- BBO headers for 76 Cutlass S
- TH200-4R transmission
- 15x8 or 15x10 widened SSIII wheels
- Front and rear lenses for 76 Cutlass S
- Usable 455 bare block
Probably lots of other things.. just hit me up.
Thread
Thread Starter
Forum
Replies
Last Post
MDchanic
Parts Wanted
0
April 23rd, 2011 07:15 AM