Bob Kelso

This is a 1967 10 bolt posi rear end out of a Buick Skylark wagon , the housing was acid dipped - primed - painted , backing plates - rear cover -yoke were bead blasted and primed - painted . All seal surfaces were polished so as to not have any burrs so as to not cut seals . New bearings - axle bearings - seals - new axle studs - upper control arm bushings , new gaskets behind the backing plates . This is backing plate to backing plate - no brakes . This has the 4 pinion factory posi unit as well as factory gears , posi is in very good condition as well as the ring and pinion .This will be a good upgrade for the 2;41 - 2:56 - 2:73 open rear you now have . This will fit the GM A body cars .Asking $750 . picked up at my location . Zip 60034 Hebron Illinois .

Bob Kelso

Because this came out of a wagon it has the bigger axle bearings .

marxjunk

and the GS guys would love to have this...have you posted it on V8buick.com

they are sought out there...very much

oldsmobiledave

The 68-70 8.2" Buick is a different animal.


Still interchangeable & useable in any 1964-1972 GM A body.


Good luck with the sale.

marxjunk

65-67 GS cars use the big bearing rears factory, and the wagons use wider brakes...and its a 3 series posi...


i never said a word about 68-72 cars....since it was listed as a 67..i just assumed it was understood..