68 69 Cutlass reproduction fenders
#1
68 69 Cutlass reproduction fenders
Hi all, has anyone on this site purchased aftermarket/reproduction fenders for 68 or 69 Cutlass. Wanted to know how they bolted up? Any fitment issues re: gaps, crease lines etc. Thanks in advance.
#7
https://classicoldsmobile.com/forums...enders-109515/
https://www.tapatalk.com/groups/real...0.html#p103001
I would also PM 69442murph as he's done a bunch of 69 restorations. I know he uses NOS when he can but he may have some experience with them
FWIW I've also seen 3-4 posts on FB that the fit is good. I've never seen anyone say the fit was terrible
It might also be worth asking Mike Fusick. I know you're local to him...
https://www.tapatalk.com/groups/real...0.html#p103001
I would also PM 69442murph as he's done a bunch of 69 restorations. I know he uses NOS when he can but he may have some experience with them
FWIW I've also seen 3-4 posts on FB that the fit is good. I've never seen anyone say the fit was terrible
It might also be worth asking Mike Fusick. I know you're local to him...
#9
Good Evening, I am not sure if you purchased anything yet, but I am restoring a 68 Cutlass Convertible and purchased replacement sheet metal from oldsparts.com in 2022. I dealt with Garrett and he was super! The body guy who is doing the car said the items (I bought a few parts) were wrapped and shipped properly to avoid damage and required very little to fit perfectly. The part #’s were LF6869 & RF6869. Hope this helps, Vin
#10
Good Evening, I am not sure if you purchased anything yet, but I am restoring a 68 Cutlass Convertible and purchased replacement sheet metal from oldsparts.com in 2022. I dealt with Garrett and he was super! The body guy who is doing the car said the items (I bought a few parts) were wrapped and shipped properly to avoid damage and required very little to fit perfectly. The part #’s were LF6869 & RF6869. Hope this helps, Vin
Thats good to know thanks for the info
Thread
Thread Starter
Forum
Replies
Last Post