Fender Interchange 1966 Dynamic 88

March 23rd, 2005, 07:33 AM

Anybody know if there are interchangable fenders or any other parts for a 1966 Olds Dynamic Holiday coupe. I bought a 1965 sight unseen online (big mistake) on the sellers confimation that they were a near perfect match. Not even close. Email me at bark_eater@hotmail.com with "olds fender" in the subject line. If you got parts email me too. I have misc parts for the 65 left.

jdorour · March 25th, 2005, 11:46 PM

Ryan,
The front fenders are the same for any full size 1966(only) Olds. The trim will be different but you can use a front fender from a Jetstar, Starfire, Ninety Eight, Delta 88 or Dymanic 88. The doors are the same for all 88 series cars (Jetstar, Starfire, Delta 88 or Dymanic 88) within the same body style. The front doors are the same for a Ninety Eight Convertible, two and four door hard top and the same body style 88 Series. The rear doors from the Ninety Eight hard top and all of the doors from the Ninety Eight Sedans are different. Same goes for the glass. Every thing from the B piller aft is different on the Ninety Eight when compared to the 88 of the same style.

All mechanical parts (except the drive shaft) will interchange between the full size cars (except the JetStar 88). The JetStar uses a small brake and rear axel in addition to using the 330CID engine. The JetStar also had the Jetaway (THM300) and the TurboHydomatic (THM400) as optional transmissions - The big engine 88's and the 98 used the THM400 as the only auto transmission.
The front bumper is the same on all full size 1966 and is a 1966 only unit.

weimer · December 10th, 2005, 03:59 PM

What about rear quarters for a '66 Dynamic 88?
I have one that is in good condition except for the rear quarters.
Thanks...

Oldsmaniac · December 18th, 2005, 06:50 PM

Quarters are the same for 65 and 66 88's with exception that Im talking about the face area....the part where it curves around for the quarter panel extentions are different from 65 to 66.....so you can use a 65 quarter on a 66 or vice versa if you use just the face of the quarter..... basic doors are the same for 65 and 66 88's. Fenders and hoods, trunklids, etc do not interchange between 65 and 66 full size cars.

66trifire · December 18th, 2005, 08:02 PM

I have a set of good fenders from a 66 88 that was parted many moons ago.Located in northeast mississippi.If I can help you out let me know.
B bodies rock

March 25th, 2005, 11:46 PM	#2 (permalink)
jdorour Senior Member Join Date: Feb 2004 Location: Atlanta, GA. Posts: 122	Ryan, The front fenders are the same for any full size 1966(only) Olds. The trim will be different but you can use a front fender from a Jetstar, Starfire, Ninety Eight, Delta 88 or Dymanic 88. The doors are the same for all 88 series cars (Jetstar, Starfire, Delta 88 or Dymanic 88) within the same body style. The front doors are the same for a Ninety Eight Convertible, two and four door hard top and the same body style 88 Series. The rear doors from the Ninety Eight hard top and all of the doors from the Ninety Eight Sedans are different. Same goes for the glass. Every thing from the B piller aft is different on the Ninety Eight when compared to the 88 of the same style. All mechanical parts (except the drive shaft) will interchange between the full size cars (except the JetStar 88). The JetStar uses a small brake and rear axel in addition to using the 330CID engine. The JetStar also had the Jetaway (THM300) and the TurboHydomatic (THM400) as optional transmissions - The big engine 88's and the 98 used the THM400 as the only auto transmission. The front bumper is the same on all full size 1966 and is a 1966 only unit. __________________ 1966 Ninety Eight Convertible - 425 Tri-Carb, Factory Dual Exh, Switch-Pitch THM400, 3.54 Posi. 1966 Catalina Wagon - 421 Tri-Power, M21, 4.11 Saf-T-Trac, 8 Bolt Wheels 1989 IROC-Z - 5.7TPI

December 10th, 2005, 03:59 PM	#3 (permalink)
weimer Junior Member Join Date: Dec 2005 Location: Bellefontaine,Ohio Posts: 1	What about rear quarters for a '66 Dynamic 88? I have one that is in good condition except for the rear quarters. Thanks... __________________ Later, WEIMER

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1970-72 W-25 Ram Air Hood	MB3110	Parts Wanted	3	April 17th, 2009 11:22 AM
Replacement/Repair Parts for '68 Toronado	conroyboy	Chassis/Body/Frame	1	August 28th, 2006 08:23 AM
94 Cutlass Ciera inline fuse Where?	gstangl	Electrical	3	July 20th, 2006 09:53 AM
67 Toro CV Joints	Tusses	Toronado	4	June 13th, 2006 02:55 AM
1964 Body Mouldings	AinoKea	Cutlass	2	March 18th, 2006 05:51 PM

March 23rd, 2005, 07:33 AM	#1 (permalink)
<Ryan B> Guest Posts: n/a	Anybody know if there are interchangable fenders or any other parts for a 1966 Olds Dynamic Holiday coupe. I bought a 1965 sight unseen online (big mistake) on the sellers confimation that they were a near perfect match. Not even close. Email me at bark_eater@hotmail.com with "olds fender" in the subject line. If you got parts email me too. I have misc parts for the 65 left.

December 18th, 2005, 06:50 PM	#4 (permalink)
Oldsmaniac Registered User Join Date: Oct 2005 Location: NJ Posts: 686	Quarters are the same for 65 and 66 88's with exception that Im talking about the face area....the part where it curves around for the quarter panel extentions are different from 65 to 66.....so you can use a 65 quarter on a 66 or vice versa if you use just the face of the quarter..... basic doors are the same for 65 and 66 88's. Fenders and hoods, trunklids, etc do not interchange between 65 and 66 full size cars.

December 18th, 2005, 08:02 PM	#5 (permalink)
66trifire Junior Member Join Date: Oct 2005 Location: northeast mississippi Posts: 5	I have a set of good fenders from a 66 88 that was parted many moons ago.Located in northeast mississippi.If I can help you out let me know. B bodies rock