Bbo Buildup And Nitrous

ooohhha442 · 05-23-2007, 02:04 PM

Hey Everybody, Im A Major Car Nut And A Newbie To Oldsmobiles, I Have A Question , How Well Do 455's Handle 125 Shot Of Nitrous? I Noticed Nobody Really Uses Nitrous On Big Block Oldsmobiles. Are They Prone To Head Gasket Failure Or Rod Bearing Failure Or? Any Information Would Be Greatly Appreciated.
Thanks

Oldsguy · 05-24-2007, 09:02 AM

Welcome to our site. I truly couldn't say from personal experience but from general knowledge I really don't think people do it because they don't need much of it. I have seen a twin turbo BBO and a couple of blown ones too so I think they can handle the cylinder head pressure. As far as bearing failure goes, don't know at all. You might ask this over at Realoldspower.com too. They have quite a few real serious racers and gearheads over there. Not to say the people here don't know their stuff because the do. Just a little bit different make-up over there, that's all. Well, good luck and again, welcome.

ooohhha442 · 05-24-2007, 10:34 AM

Ok Thanks For The Info.
This Is An Awsome Site And Great Tech!
Thanks
Eric

05-23-2007, 02:04 PM	#1 (permalink)
ooohhha442 Junior Member Join Date: May 2007 Posts: 2	Bbo Buildup And Nitrous Hey Everybody, Im A Major Car Nut And A Newbie To Oldsmobiles, I Have A Question , How Well Do 455's Handle 125 Shot Of Nitrous? I Noticed Nobody Really Uses Nitrous On Big Block Oldsmobiles. Are They Prone To Head Gasket Failure Or Rod Bearing Failure Or? Any Information Would Be Greatly Appreciated. Thanks

05-24-2007, 09:02 AM	#2 (permalink)
Oldsguy Administrator Join Date: May 2004 Location: Lees Summit MO Posts: 2,859	Welcome to our site. I truly couldn't say from personal experience but from general knowledge I really don't think people do it because they don't need much of it. I have seen a twin turbo BBO and a couple of blown ones too so I think they can handle the cylinder head pressure. As far as bearing failure goes, don't know at all. You might ask this over at Realoldspower.com too. They have quite a few real serious racers and gearheads over there. Not to say the people here don't know their stuff because the do. Just a little bit different make-up over there, that's all. Well, good luck and again, welcome. __________________ Dan '46 2 door

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-24-2007, 10:34 AM	#3 (permalink)
ooohhha442 Junior Member Join Date: May 2007 Posts: 2	Ok Thanks For The Info. This Is An Awsome Site And Great Tech! Thanks Eric