Quote:
Originally Posted by mcutlass1969
Guys
I am swaping out the olds 350 to a 76 olds 455. I have added the Edelbrock Heads, intake and carb. I have run into a bit of a snag on a few things.
Setting the Rockers. Do you set them like Chevy's? Tighten by hand till you feel the tension begin, then tighten with a wrench 1/2 turn, then tighten the set screw?
I have the Brackets, pulley's from the 350 but they are not lining up with the 455 Harmonic Balancer pulley? also I have the Edelbrock heads so that my change this a little. It appears that the bolt holes line up but spacing out from the front of the motor is the issue.
Need a wiring diagram for the 69 cutlass and 455 motor. I have lost some of my labels off the wire when I pulled the old motor?
Probably will have a few more questions as I go along.
|
what are you going to do with the 350? thanks