[bjtstarfire]

Question About the way my car sits from side to side across the back and front.

First the suspension was overhauled by me with all new components and they everything is seated correctly and the car had this slight issue prior to the overhaul.

From the front of the car it looks level from side to side even though the measurements are only out about one half of an inch off. The measurements were taken on a flat surface to the top of the front wheel lips. I am not too bugged by this.

From the back the car looks un-level from side to side (not to bad, no one can really key in on it – but I can). The measurements are out about one and one half of an inch off. The measurements were taken on a flat surface to the top of the rear wheel lips and to the frame rail aft of the rear tires. If I measure off the axel they are right on the money and level.

Should I worry about this? Should I take it to a frame shop or will this create more problems?

Does any one have the correct ride height dimensions that they can give me and the reference points?

Ben