Quote:
Originally Posted by Dapapadon
OK guys, I was checking out craigslist a while back looking for parts for my 67 Cutlass Supreme. To make a long story short I bought another 67 Supreme. This one needs a lot less work. Which will save me some time and money, I hope.  Here's a link to a picture. I've already started to disassemble and do bodywork.
http://i217.photobucket.com/albums/c...don/67Cut1.jpg
I just recently ran across a 67 Vista Cruiser parts car. Haven't bought it. But do have a few questions for the knowledgeable here. First, is the rearend the same as mine? Or does it have the larger 5 on 5 bolt pattern? Second, I noticed from the photos the owner emailed me that it has a 3 speed automatic. Would this be a switch pitch TH400?
Don |
The VC is an A body, just like the Cutlass. The rear axle will bolt up, though the VC may have larger brakes and bearings. I know the 68-72 VCs are that way, not sure about the older ones.
The trans should be a TH400 (or, if the engine is a 330, it might be the lower strength TH375 version of the 400). Check the electrical connector on the side of the trans. One wire means regular TH400, two wires means switch pitch.