Quote:
Originally Posted by W30post
Carb has been completely gone through and has no binding. The throttle shafts have been drilled and bronze guides installed for good consistent sealing. The distributor is a new unit and the mechanical advance is not sticking. I cannot say if the vacuum advance is sticking as I have not checked.
Any guesses?
|
Are you completely sure the carb throttle plates are closing correctly? I've had a similar situation and the problem ended up being the gasket between the float bowl and the throttle body on the Qjet. The gasket was just a little ragged in the throttle openings and the throttle plates would sometimes hang up slightly. Be particularly careful in checking the secondaries. Assuming this is a Qjet, be sure the link that forces the secondaries closed is adjusted properly.